20 Most Recent Nor-Lake KLB77810C Commercial Freezer - Page 10 Questions & Answers

Hi. The deep freezer is working but not freezing

Chest freezers have the condenser coil in the side walls do not drill into the sdes to install locks without knowing exactly where the coIL is. I would think a locksmith could install a lock for you. That or secure your garage better.

hi i have same problem one of my lodgers left the door open and it froze thick with ice i defrosted it and let it dry for 3 days and was fine for a couple of days then it defrosted so i switched it of for 24 hours it worked fine for a day before it defrosted again could you email me with any help thanks [email protected] matt

Apparently a Western Auto brand sold in the 1950's, 1960's, and 1970's. Google shows some Amazon.com manuals for sale: Example of one: https://www.amazon.com/gp/offer-listing/B01N5VWE77/ref=dp_olp_used_mbc?ie=UTF8&condition=used

Be sure the supply line is clear and the valve is turned on.

Bagai mana cara memembuka hp imo w8800

The colder the internal temperature, the greater the likelihood of condensation on the external surfaces under humid conditions. Generally harmless. Check the insulation around the door. If it is failing, there may not be an economical fix.

The wiring diagram for the compressor, start and run caps, potential relay is attached

https://skidsteerloadermanual.com/store/products/bobcat-753-bics-loader-service-manual-download/

Not until it gets back to operating temperature if around 0F

Probably a clogged defrost drain

Either replace ice maker or water valve

notify a service company for it

Power surge probably damaged the electronic board

Probably the relay you here clicking is bad.

It’s a thermostat

try manufacturer

Found the solution for my machine with exact same symotoms: the hard water had covered the infrared source and/or receiver. They are opposing black and transparent 3mm circles on the left and right wall when you look inside your icemakee. They are supposed to detect if ice cubes pile up so high that they fisrupt the direct liner of view between those 2 dots.
Just clean them with a wet acidic solution to clean of the hardness, e.g. use vinegar or lemon juice.
Worked for me.

Hi imt45,

Serious enough!
I would advise you on this occasion to call service.

These guys are good!
A&E factory service does most brands warranty services.
They are open 7days/24hours nation wide.
call tonight! 1-800-905-9505

I am happy to assist you!
Neil
PS. Before you leave this site please leave a "Problem Solved" rating for me on fixya.com

Running light may cut on and off when compressor does the same. Probably normal