20 Most Recent
Pioneer VSX-305 Receiver - Page 9 Questions & Answers
Troubleshooting pioneer vsx-521 av receiver right channel problem crackles
Check to see that the A/C power cord is plugged into the electrical outlet and the power on the unit is turned "On" if the receiver will not power up. Test another appliance in the same outlet to check that it is "hot." Check the household fuse box for blown fuses and tripped breakers. Reset breakers and replace blown fuses with others of the exact same rating. If you are using the remote control, check the batteries and replace them, if necessary. As a last measure, remove the power cord from the electrical outlet and then reconnect it to try and reset the system.
Pioneer htz-121dvd - I need to connect HDMI input for 5.1 surround sound, how can I do it
It will probably be easier to wire the sound bar to the "Audio Out"" on the TV, the DVD player to the HDMI on the TV then change the settings in the TV.
On the back of most TV's there are 'Phono Jack' connectors and newer TV's have a 'Digital Out' that uses an Optical cable to transfer the sound. Use one of these to connect the sound bar and usually anything you play through the TV will play through the sound bar.
Depending on your TV, the settings to switch to the sound bar will be in the Sound or Audio section.
Why won't Pioneer VSX-819H reset?
http://audio.manualsonline.com/manuals/mfg/pioneer/vsx819hk.html
It's in the manual. Page 12.
Resetting the Main Unit
Use this procedure to reset all the receiver's settings to the factory default. Use the front panel controls to do this.
1 Switch the receiver into standby.
2 While holding down the BAND button, press and hold the STANDBY/ON button for about two seconds.
3 When you see RESET? appear in the display, press AUTO SURROUND/STREAM DIRECT.
OK? shows in the display.
4 Press STEREO/A.L.C to confirm.
OK appears in the display to indicate that the receiver has been reset to the factory settings.
I have a pioneer vsx d503s and the standby light is on. But the receiver will not come on
I sounds like you may have a problem in either one of the Regulator circuits, or, one of the Power Amplifier outputs. If the protect circuit detects DC or Low Impedance on one or more of the speaker lines, it will not fire up the high power section of the power supply. Further troubleshooting will require some working knowledge of power amp and power supply circuits. I've got a .pdf copy of the Service Manual if that will help you.
Please let me know what your level of troubleshooting ability is, and whether the manual will help you.
-Petra
Pioneer vsx d712 with amp error
You could have a bad speaker or wire! If it powers up ok try hooking one speaker at a time and when it shuts down you will know what speaker/channel is causing the problem.
Not finding what you are looking for?