Technics SL-DZ1200 CD Player - Answered Questions & Fixed issues

As a DJ myself, I have seen that before. On a night that the equipment will not be used, UNPLUG ALL CABLES AND POWER, then use an eyedropper to drip a drop or 2 of water on the spindle and manually spin the table a few turns., wait about 5 minutes, then drop a couple drops of rubbing alcohol and again spin the table. Wait a couple hours or over night, and follow with a couple drops of oil. NO MORE THAN 3 DROPS OF ANY OF THESE!!

http://sparedparts.com/products/technics-sl-dz1200-service-manual-complete

Not all CD players can or will play CD's burned in a PC. Sometimes the CD player is to old, so not compatible with these CDs. Sometimes the player just does not play these CD's, because of rights protection. A CD burned in a PC is less reflective than an normal music CD. Normal CD's do have a metal coating and are highly reflective. Burned CD's have a dye, and where the laser burned the dye, it only changed colour. Making it less reflective. All modern CD playes should be capable of playing CD r's. But the player that is really compatible, is labelled CDr and CDrw compatible.

You should realize that this player is about 20 years old. It was not designed to read CD-R or CD-RW media. The signal from these media types is different from audio CDs you buy.

I DONT UNDERSTAND

Lazer is shot, Not reading info from the disc anymore,

you buy megapro cd volume 23

volume 23

This can be caused by many hours on the unit or a bad solder joint on the PCB. It will need to be seen by a repair Technician.

Most likely the deck needs a new belt installed- they are not always so easy depending on where they are located. This is what it sounds like to me- I have been doing electronics repairs for 40 years so far. I bet I could fix it.

The problem is in the microprocessor ic, it controls selectors, display and mechanical devices. Did you have a recent thunderstorm? which would explain why it is none functional, this is a long shot, unplug unit from wall receptical and any other wires that are attached, now press and hold power for 60 seconds to drain residual voltage in attempt to reset the processor, if this fails cheaper to replace player.

goto this web sitehttp://www.retrevo.com/d/ds/progress?doc=4f111afdbb731cd20f7c182c03c53206&u=1&rk=0.8167665906240874

The problem is in the laser pickup assembly, buy a CD cleaning kit and follow instructions, if this fails! far cheaper to replace the player.

I had the same problem. Replacing the sensor is not gonna help. it is a focus problem. I had to fold a small piece of paper and put it under the sensor to raise it up alittle then you screw it in. The size of the paper you will have to figure out for yourself, but it will help u fix your problem

Change the motor disc spindle they are all the problem

Try to insert into your computer. Right click on it when It shows up in my computer and click format. It will whip out the card and any errors that might be in it

the firmware depends on display. if the display does not supports MP3, firmware upgrading will not help. most of the time upgrading firmware will not help playing MP3.

Hi,

I'm not sure if you are referring to "Sensor Sheet".

If not, please click this LINK to check the parts.

Hope I helped you.
Have a nice day!
Thanks for using Fixya.

my mega pro 100n was not able to play or open what will i do pls help me my face book account rodel adriatico

Alotta of the times if you have an sd card inserted take it out then repower up the dz 1200 and wallah your eject button is rollin!