20 Most Recent
Taylor 1528 Wireless Digital Indoor Outdoor Thermometer - Page 2 Questions & Answers
Replaced batteries, outsid temp. does not display
Base Station Battery Installation
·Remove the printed vinyl label from the LCD screen of the base station
·Position the remote sensor near the base station
·Open the battery compartment at the back of the base station and insert (2) AA batteries according to the polarity markings. Replace the battery compartment cover.
·Within a short time the RF signal icon (located to the left of the outdoor temperature channel indicator) will start flashing. This indicates that the base station is ready to pick up the RF outdoor temperature signal from the remote sensor. It will continue to flash for 3 minutes or until the signal from the remote sensor is detected.
Register the Remote Sensor
·Open the battery compartment at the back of the remote sensor and slide the channel selector switch to your desired channel. For the first remote you may select any channel, for additional remotes select any unused channel
·Insert (2) AAA batteries according to the polarity markings. Be sure to install the batteries in the remote within the time that the RF signal icon is flashing on the base station.
1541 WeatherGuide Wireless Weather Forecaster with Barometer
I have a Taylor 2750(R) Rain Guage and can not
I copied the following text from the users manual.The receiver unit is factory set to diplay total rainfall in inches. To switch measurement to millimeters, press and hold the "-" butto for 3 seconds. The display will switch to mllimeters.The trick also works to switch from mm to in.
Not finding what you are looking for?