Top 20 Clymer EvinrudeJohnson Outboard Shop Manual 48 235 HP Questions & Answers

Have you checked the oil quantity AND quality in your drive? You can drain the gearbox by removing the lower drain plug and the filler plug on the drive. It's possibily full of water and your drive just seize when hot...

Engine # MAY be the same. Should be top of crankcase.

yes servicewater pump checked over was it stored off the boat if attached to an aluminum hull (electrolysis ) check over for corrosion internal and all wiring connections in any water jackets or intakes ..mud wasp nestsor rodents

A Evinrude 4BRCI is a 1981 4 HP 2 stroke Short shaft 15"

There should be two hot wires one from the battery and one from the switch the one from the switch check should be hot when the key is held on the start if it is the starter solenoid is bad

An evinrude dealer may be able to help you

1986 Just google the model and parts diagrams are available

Check fuel lines and breather on tank

I have had ones that I had to drill out,the centre of the pin rusts and ends up being larger than the hole,not an easy job

2stoke engine no less than 100psi ! 4stroke the same but not a critical ! which engine have you ??

You will need the model Nos. This is on the tag on stern leg its a row mainly letters.Google will do the rest for you Good luck

I need more info. Two hose fuel line? If single hose with primer bulb, can you keep it running by pumping primer bulb? Picture would help. Will it idle for longer? Will it go over half throttle?

You will need the MODEL number After that all the info is on the net Cheers & good luck Capt Caravonica

You will need the model Number rather than the serial. .This is on the tag usually on the stern leg.It should be mainly letters Once you have this go on google & type "What year is my evinrude

How old? If it is the old system that looks like a spiral ramp, very carefully. I knot one end, feed it into the hole at the top and then feed it around without taking apart the starter. The spring is a pain to work with.

You should contact Authorized Service Immediately!

tell me exactly what your tryin to set up , are you fittin the engine and controls etc or just settin up the engine to run ?

What year is my Kiekhefer Mercury Outboard SN 389664, Mdl-KF-7

Your head gasket is blown or motor has seized due too overheating or lack of oil

remove it and soak in tub of diesl