20 Most Recent Cub Cadet Op's Manual Model Lt1042 Lt1045 Lt1046 Lt1050 - Page 2 Questions & Answers

My GT 1052 has a spring loaded idler pulley to maintain traction on the belt. If the belt came off a pulley once, it's probably stretched or some of the internal cords have broken, allowing it to twist and come off the pulley. You should replace it immediately. One Note: Be SURE to get a belt with Kevlar - I used a lesser belt the first time, and it only lasted a short while. Considering the amount of effort to change the belt, it's better to buy the slightly more expensive one's with Kevlar as they last MUCH longer.

only way is to change pulley size on pump / has built in gear

see if there is a fuse for the clutch near the sw

remove wheels and repack yourself

you have to remove wheels and repack bearings

charge the battery start tractor and check the voltage at battery terminals should min 12volts and rise to about 13.8volts if not charger is RS

Did you check voltage on the battery, and did you leave it running at a high idle? (low idle can consume battery voltage instead of charging it. On many tractors the lights do not run unless the motor is running so don't let that throw you off. Things to checkMake sure no fuses popped. Makes sure you have gasTry jumping it to see if it starts If not, it sounds like you may have a short, or may have a safety switch that is acting up. look for loose, broken, damaged wires. Check to see if any wires are hot when the battery is fully charged. Try that and repost what you do or don't find.