20 Most Recent
Toro 52" 27hp Z Master Zero Turn Lawn Mower - Page 8 Questions & Answers
My toro snow blower starts but won't shift gears
Typical snow blower shifts by moving a drive wheel on a hexoganal shaped shaft. Likely the wheel has rusted to the shaft from insufficient maintenance.
Remove the rear/bottom cover plate to access the transmission (usually 4 bolts). Lubricate shaft/wheel with penetrating oil and work free.
Avoid getting oil on the drive wheel and disc or thoroughly clean the disc and wheel with a liberal application of alchohol until wiping with a rag comes clean.
Lubricate any drive chains as well.
12/2/2019 4:18:18 PM •
Toro Garden
•
Answered
on Dec 02, 2019
Toro CCR 2450 snowblower won't start.
Try a short burst of starter fluid into the carburetor and promptly pull starter. If it runs for a couple seconds and quits then the carburetor is not delivering fuel.
If it doesnt run on starter fluid then either flooded, insufficient spark, or poor compression / crankcase leak.
10/27/2019 12:02:02 PM •
Toro Garden
•
Answered
on Oct 27, 2019
Toro 71225 transmission or drive belt
Check and see if there is a shear or safety pin in one of the drive pulleys that has broken.See if there is a pulley that turns by hand when this happens. Could be one has broken but grabs for a little bit. Also check the drive belt and see if it is slipping Check all the drive areas . BE SAFE BY TAKING THE KEY OUT AND TRYING BY HAND>
9/23/2019 1:23:25 AM •
Toro Garden
•
Answered
on Sep 23, 2019
Not finding what you are looking for?