20 Most Recent
Mitsubishi WD-62525 62" Rear Projection HDTV - Page 3 Questions & Answers
Error code 1 2
I found this list of codes
Error Code Probable Cause
12 No error detected
22 Recovery from momentary Reset
32 Lamp Cover open
33 Air Filter Cover open
34 Lamp abnormality
35 Chassis Fan failure
36 Exhaust (Back Cover) or Lamp Ballast Fan failure
37 Engine (DMD or Lamp) Fan failure
38 Excess Lamp Temperature
39 Excess DMD Temperature
41 Short Detected
44 DVI Cable (between Chassis and Engine) disconnected
How do I change inputs on my mitsubishi projection tv
You need the original remote. there is 3 up/down buttons, one is volume, one is channel, the other is input. The input up/down will scroll through all the inputs. Some of these TV's don't have it on the front panel
No power, no lights, nothing
check the power supply cable,if ok open and check fuse if blown, then test the power ic.if shorting then replace and test the tv on power again
Replaced dlp chip
Go back and make sure you do not have any loose or missing cables first.
How do i set the color for picture
Projection TV sets have two very common problems. One is convergence ( 3D/Warped video) the other is CRT fluid ( Dull Video). Below are more details for both items. Also, complete repair kits with instructions and repair support are avail from site such as www.TvRepairKits.com
Common Problem #1) Convergence has gone out
Projection TV sets need to have all three colors - RED - BLUE - GREEN - lined up correctly on the screen in order for the video to look normal. When its out of alignment the video will look 3D, wavy, distorted, etc. Most of the time you just need to adjust your convergence in the TV menu. If you cannot adjust it in the menu - then your convergence is broken and needs to be repaired.
This is a very common failure on these projection sets and a fairly simple DIY fix. All projection sets including Samsung, RCA, Sony, Philip Magnavox, Panasonic, Pioneer, Akai, GE, JVC, Toshiba, and others at some point will have the same problem.
Says I need to fix airflow problem
It is telling you that the unit is overheating for a lack of air flowing over the globe. Check that the air slots are not blocked. the fan motor is working and any filters are clean and not blocked.
Black spot in bottom of tv
I just had my caps replaced and after the tech put it back together there was a spot. He tok the screen off and cleaned the mirrors around the bulb and the large mirrors(they were reaaaalllllly dirty. It did brighten up the picture and it looks crisper, oh and the spot was gone.
P.S.. Like nettiser stated. If it's unde warrenty have them do it. If you drop something "you will be pissed" if you don't !
Not finding what you are looking for?