20 Most Recent
Orion TVDVD092 9 in. TV/DVD Combo - Page 4 Questions & Answers
VHS stuck in Orion tv how do I get it out
https://www.howtomendit.com/answers.php?id=73308
Besides trying the upside down approach, try Sharon's tip at the very bottom of the link.
Quoting:
"I just had a tape stuck in a VCR/TV combo so went on the Internet for help and all other answers were to take the top off the VCR which of course is not possible with a tv combo.
While stuck the the power would turn on it would just emit a low moan-whining noise for a few seconds starting strong then running down and then power off. Couldn't watch TV in that state, it would automatically power off.
So I got down comfortable on the floor eye level with the input slot with the flapping door cover and pressed the power button then quickly with my fingers of one hand inserted them in the tape load slot and using my middle fingers continously began pushing up on the top edge of the cassette in a stiff but quick flicking motion over and over again (like trying to physically force the tape up with intermittent prodding short and quick strokes so it could clear the lip if the eject mechanism kicked in) while simultaneously pressing and holding the eject button with my other hand and after a few tries and 5 or six upward prods on the front top edge of the cassette the eject mechanism activated and spit out the tape.
Sharon
June 2007"
Have a Orion tv. Have sound, screen comes on for 5 seconds, then goes black..
Back - light problem. Check and replace damaged component/s at its back-light inverter board, or replace this board as card basis. If you wish to get some details; check the site linked here. Surf the site with patience. Pull up older posts. It will be best to replace the inverter board as card basis.
http://electronicshelponline.blogspot.com/
To some model sets; especially LED back-lighted types; the back-light inverter circuit will be part of the main power supply board [SMPS]. In such cases, the power supply board might need replacement. To some models sets, the back-light inverter and SMPS section circuit will be integrated at its main board itself. If so; the main board should be replaced. To some models of sets, all these section circuit will be integrated at its main board. If this is the case, you have to replace the main digital board./
Not finding what you are looking for?