20 Most Recent Proform XP 580 Trainer Treadmill - Page 9 Questions & Answers

Free online manual: https://www.manualslib.com/products/Proform-Xp-210-U-3248523.html Proform XP 210 Manuals

Its showing e6

check adjust belt tension may have to clean under belt area as there could be a build up that is stopping the free movement of the belt as it gets hot

ProForm 6 0 Rt Treadmill Manual Table Of Contents

there is a clip latch that u need to move to pull the treadmill back down, its on the left side on top

Hi sir. Please see the videos attached. How To Lubricate Treadmill LED Blink Patterns on the Control Board Treadmill 1) See if the drive belt of main motor is Loose or maybe has Oil, clean very well and tight the belt very well. If the problem persist, time to replace the board and Walking belt. Blessing [email protected] celular+WhatsApp:+50588611441

Hi sir Please do the next: How to Lubricate an Elliptical Fitness Exercise Equipment Elliptical Noise Troubleshooting Blessing [email protected] celular+WhatsApp:+50588611441

Hi sir 1) Please open the covert where the main motor is, disconnect the connector from the Incline motor. 2) Turn On the treadmill, and see what happen. 3) If the problem does Not appear , is indication the controller motor board is defective. Since the controller motor board has 3 power supply: 1) Console 2) Main Motor 3) Incline Motor. LED Blink Patterns on the Control Board Treadmill Blessing [email protected] celular+WhatsApp:+50588611441

Hi sir Please review if the 1)outlet is Off, put some lamps and test if o.k 2) if is o.k test the c.breaker or fuse in the treadmill. 3) if are o.k See if the Red Led in the controller motor board is ON you must need to open the covert where the main motor is. 4) if the Red Led is ON, and the machine NOT work, test with a Multimeter or DMM, if there are Voltage in the terminal marked: + - are the wires for to feed the DC motor. if there are Not TIME TO replace the Controller Motor board. If there are test the motor you can use battery for a Drill has 18 Vdc.Depend if NOT work repair or replace Main Motor, of course See If the Drive Belt is O.K, or are broken or loose it!! Blessing [email protected] celular+WhatsApp:+50588611441 LED Blink Patterns on the Control Board Treadmill

Dear Sir: Hi , this is symptom, that Matrix inside of Console is defective Is time of replacing , someone can do fix it, BUT the problem if the service man, want to do it. Blessing [email protected] celular+WhatsApp:+50588611441