Treadmills have up to a 15 amp power draw. They are like space heaters, Proform often recommends having a dedicated 15-20 amp circuit for a treadmill. Ellipticals have less power draw.I repair most Icon products, is this a new problem with an old treadmill? If it is a new treadmill, call the number in the front of the manual, if they can't fix it over the phone, there is a good warranty on it. At least for a little while. ;-)
You must LUBE the deck belt first, this happen because you do not lube maintenance schedule, Do it every week from use.Maybe you have a WORN deck belt.2) LUBE the rollers bearing front and end, use WD-40 3) Test the drive belt motor, for cracking or worn, and replace.God bless you
1) LUBE THE deck belt, maybe you have WORN deck belt, time to replace2) LUBE the rollers bearing too, very well 3) test the bearing from the main motor, time to repair.God bless you
1) lube the deck belt, may you have a worn deck belt and sound very bad2) lube the rollers bearing too3) test the bearing from the main bearing , maybe is time to repair and replace.God bless you
I can suggest a way to make the machine work without the key. If you remove the control panel cover you will see where the key switch is located. If you have a simple toggle switch you can remove the wires from the key switch and attach them to the toggle switch. then mount the switch in a position where you can easily turn it on and off. That is how I fixed mine.
RUN the software calibration for diagnose, troubleshooitng, fix it.2) Lube the gear+shaft from elevation Motor 3) adjust the POT from elevation motor, see diagrams attached.God bless you
you must try to open the display board. 1) tight the ribbon cable inside, clean it, very well 2) clean the keypads switchs for dirty, dust, oxide, bad contact, or open contacts. you can use contacts cleaners spray. with carefully. unplugged the power cord.3) tight the wires connector from display board vs lower board.God bless you
1)Please lube the gear and shaft, very well from elevation motor2) Test the motor, and replace if necessary.,see for ball bearing and lube3) Lube the deck belt, and guide for instruction manuals.4) Test the main switch, and reset button with VOM, for open, test and replace see the diagram how to do it.God bless you
1) Lube the deck belt, maybe is worn, to due the lack of maintenance.2) Lube the rollers bearing front and rear very well.3) TEST THE voltage motor input, if there are voltage, the motor need repair.4) Test the output voltage board, for input voltage motor, if there are NOT the board is faulty.God bless you