20 Most Recent Behringer C1U Microphone - Page 4 Questions & Answers

Check and replace damaged component/s at its main power supply section. Contact any service technician. If you wish to get some details; check the site linked here. Viewing it in "Mosaic" or "Magazine" will make surf easy. Surf the site with patience. Pull up older posts. Do asearch by type in the brand name of your device at its search box. http://electronicshelponline.blogspot.com/

Sounds like main amplifier section circuit fault. Check all the supply connections and make sure that there is no loose contact, before you do anything. If you wish to get some details; check the site linked here. Pull up older posts. Surf the site with patience. http://electro-medical.blogspot.com/ http://electronicshelponline.blogspot.com/ Search the site by type in the "Brand Name" (Exclude the model number) to your device, in the "Search box at the top right of the display window of the Homepage" to get gathered related posts.

Battery dead in mic.

Behringer Virtube VT100FX User Manual Table Of Contents

Is there any fuses inside the unit or just the one on the back inside that cylindrical fuse holder that you can push, twist and remove? Mine will not power and I want to open up the box if there is any fuses there and I will check for cracks near the pots, etc. as well while I am inside the power box. I already removed the box fromt heback. Just need to open it up now.

200W at 240 V = 0.38 Amps

Easy to do - just get a patch cord that has a stereo 1/8" plug on one end and two phono (RCA) plugs on the other end. Plug the phono plugs into the "Tape IN" jacks on the mixer and use the "Tape" volume to adjust the sound level. It's best to turn your laptop or tablet volume up to maximum, then adjust the volume on the mixer.

It is a bit fuzzy for me, how everything is connected, but just plugging in cables where they fit won't always work. Special not with tulip plugs and cables. Not sure you Amp has speaker switches, but you could start there. NEVER switch on an amplifier, while the volume button is open. Not even when it is half way. Please every time you want to change something, first lower the volume. First try to get any sound from the amplifier in the speakers. When you have something like noise in the speakers, then you can test an input on the amp. You could put in a pice of wire in and choose the correct input button and then turn up the volume. If it starts humming, you are on the correct input. On that input you plug in a device giving enough power (voltage must be within the range for that input) and check if it works. When you want to know anything about voltages going in an amplifier I add a wiki page, and for all other inputs you can find the levels on Wiki too. Line level Wikipedia the free encyclopedia

What is the question?

Sounds like feedback

Service manuals are on line, try a local repair shop.

I do not know, but try from the inside!

this may help

Check your inputs and try swaping channels.

What are you asking. Be sure your input levels are correct.

That can be a real bummer to find. Swap connections with another channel. If the problem channel changes it is the external connections, if not it is the mixer. You would have to quit using that channel or get it repaired.