20 Most Recent
Homelite Mighty Lite Blowervac - Page 6 Questions & Answers
Homelite line trimmer wont start
take plug out and see if you have spark then spray a little starting fluid in the hole and quickly put plug back in and try to start it again
42cc homelite fuel line routing.
Perhaps you can follow these simple steps to solve your problem:
Start and let the saw run until its run out due to empty gas. Take off the cylinder cover, which sits on top of the saw. Using the needle nose pliers grab the rear end of the fuel line and gently pull it off the carburetor.
Remove the gas filler cap from the tank. Use the needle nose pliers to grab the fuel filter in the bottom of the tank. Pull out the fuel filter and the entire fuel line from the saw. Use the pliers to pinch the fuel line and with your hand pull the fuel filter off the fuel line. Throw both of these away.
Cut off about 10 inches of new fuel line and insert the metal wire into the fuel line. Push the wire and fuel line into the gas tank and through the hole at the bottom until you see the line come out near the carburetor. Don't connect it to the carburetor yet.
Pull the metal wire out of the line and cut off any excess line with the scissors. Pull it back out of the tank slightly and insert the fuel filter into the fuel line. Push them back into the tank.Use the needle nose pliers to grab the rear end of the fuel line and attach it to the carburetor.
I hope these helps. ??
How to adjust oil flow to homelite 3514c. UT10640.
Chainsaw oil pumps are fairly simple affairs, to increase oil flow you obviously cannot increase the engine speed, so you increase the throw of the pump shaft, so the pump shaft not only rotates, it moves back and forth ( the throw ) so the back of the pump shaft is cut off at an angle, the adjuster screw sits on the back of the shaft, so now when it rotates it moves in and out due to this angle, so the close the screw is to the centre of the shaft the lesser the throw, the further out the bigger the throw, so unscrewing the adjuster ( anti clockwise ) increases the flow, and visa versa.
What is the fuel mixture for a homelite 30cc engine on a small tiller/cultivator
The oil ratio is not adjusted to the engine it is the formulation of the oil. You mix your oil the way the bottle states. I have been working on 2 cycle engines since the 70's at a motorcycle, ATV and lawn & garden dealership. If you have doubts about a 50:1 oil do like I do and put 8/10ths of a gallon of gas in you jug and use a bottle of oil for a gallon and mix.
Not finding what you are looking for?