20 Most Recent
Homelite Carburetor Trimmer Blower Mightylite Versatool - Page 2 Questions & Answers
Where is the spark arrestor on homelite 26bp leaf blower
The spark arrestor screen sits inside the muffler on a gas-powered leaf blower. These screens help prevent heated gases from escaping the internal combustion engines.
https://www.ehow.com/info_8446641_important-arrestor-screen-leaf-blower.html
Homelite 410 chainsaw wopn't keep running
Chances are, the diaphragms are old/deteriorated/stiff, but you could try turning adjustment needle closest to carb, clockwise and counterclockwise 1/4 to 1/2 turn (=/-) and see if idle improves. Usually, the easiest thing to do is replace carb.
Need to know best way
Regarding the adjustment procedure you generally start your low and high mixture screws at one turn from seat, or slowly turn them in all the way until they bottom out and then back them out one full turn. You will adjust the high speed mixture screw at full throttle and get the median point between too rich (loads up) and too lean (dies out). You will want to do the same thing with the idle mixture screw, just adjust at idle rpm. You will also adjust the low idle mixture screw to give you a smooth transition from idle to throttle up. Once this is obtained, you adjust the third or idle speed screw low enough so the chain does not turn at idle rpm but high enough so the saw doesn't cut off. Hope this gets you going.
Homelite line trimmer wont start
take plug out and see if you have spark then spray a little starting fluid in the hole and quickly put plug back in and try to start it again
42cc homelite fuel line routing.
Perhaps you can follow these simple steps to solve your problem:
Start and let the saw run until its run out due to empty gas. Take off the cylinder cover, which sits on top of the saw. Using the needle nose pliers grab the rear end of the fuel line and gently pull it off the carburetor.
Remove the gas filler cap from the tank. Use the needle nose pliers to grab the fuel filter in the bottom of the tank. Pull out the fuel filter and the entire fuel line from the saw. Use the pliers to pinch the fuel line and with your hand pull the fuel filter off the fuel line. Throw both of these away.
Cut off about 10 inches of new fuel line and insert the metal wire into the fuel line. Push the wire and fuel line into the gas tank and through the hole at the bottom until you see the line come out near the carburetor. Don't connect it to the carburetor yet.
Pull the metal wire out of the line and cut off any excess line with the scissors. Pull it back out of the tank slightly and insert the fuel filter into the fuel line. Push them back into the tank.Use the needle nose pliers to grab the rear end of the fuel line and attach it to the carburetor.
I hope these helps. ??
How to adjust oil flow to homelite 3514c. UT10640.
Chainsaw oil pumps are fairly simple affairs, to increase oil flow you obviously cannot increase the engine speed, so you increase the throw of the pump shaft, so the pump shaft not only rotates, it moves back and forth ( the throw ) so the back of the pump shaft is cut off at an angle, the adjuster screw sits on the back of the shaft, so now when it rotates it moves in and out due to this angle, so the close the screw is to the centre of the shaft the lesser the throw, the further out the bigger the throw, so unscrewing the adjuster ( anti clockwise ) increases the flow, and visa versa.
Not finding what you are looking for?