20 Most Recent Stanley 1600PSI Pressure Washer w 20ft Hose Accessories - Page 2 Questions & Answers

The valve-o-rings + [ parbaks seals ] where the pressure can be adjusted with. Control the water inlet filter or hose that there are no waterlock couplers are used or is mounted on the wrong site on the hose , that it is used as water inlet on the tap.

This is a terrible tool took it apart to get the blade out of the handle and haven't been able to get it back together again.

Try manufacturer web site.

Hi Chris: It is usually easiest to rest the weight on the tailgate of a pickup truck (or some other device) and then slip out of the harness. Another technique is to lift bend forward while at the same time rising one shoulder and lowering the other. That will create "slack" on the low shoulder side allowing you to get that arm out. Cheers

HERES A LINK,I THINK ITS WHAT YOU NEED.... http://docs-europe.electrocomponents.com/webdocs/04f7/0900766b804f72b4.pdf

Gerard, PLEASE contact me at (941) 391-5152 or [email protected] so I can hire you to replace the batteries in my Stanley barflex bf0109 light like you did above with vastly more run time mAh. I need someone to do it for me. I'm disabled. I just joined fixya.

Thanks,
Wallace Franklin Banach...

Disconnect the wand from the washer if you get water coming out of the discharge, the problem is in your wand or the line is plugged going to the wand.

If you switch the unit on and water spits out of a connection, that's where you either put the O-rings or replace them.