Mi T M MiTM Generator 9hp Honda 5000 Watt ES - Page 3 - Answered Questions & Fixed issues
How to set the float level in an etq tg1200 generator
Float levels don't just go bad. But that said you pull the carb and turn it upside down and set the float to be level with the bottom of the carb (bottom with the carb upside down.) Most new stuff doesn't have an adjustment. They break fairly easily. Don't ask how I know.As long as you have it apart, pull the float and hold it down in a cup of fairly hot water and see if it bubbles which would indicate a hole in the float which would let too much gas into the carb causing flooding.Make sure you clean the needle valve and seat and the carb inside while you are at it.
7/2/2023 12:00:20 AM •
Electrical...
•
Answered
on Jul 02, 2023
•
407 views
Powermate wont start.coil pulls real hard.
Recoil starter rope pulls hard, yes?
Remove spark plug and see if it's easier. If no change, remove recoil starter and try rotating the flywheel by hand. Comment below for further assistance.
5/24/2023 4:16:08 PM •
Electrical...
•
Answered
on May 24, 2023
•
59 views
Can you use 12/2 romex for low volage lighting
Technically, NO.
Using Romex cable inside a buried conduit is NOT ACCEPTABLE as a buried conduit is considered a damp location due to the potential for water condensation inside the conduit and Romex is not rated for wet or damp locations.
To meet code requirement for conductors inside a conduit you'll need to meet 3 major requirements
1. All conductor insulation must be rated to the highest voltage of any circuit inside the conduit.
2. A buried conduit is a damp location.
3. Conduit capacity restrictions.
4/18/2023 11:02:24 AM •
Electrical...
•
Answered
on Apr 18, 2023
•
50 views
Not finding what you are looking for?