Top 20 Concept DVD-168C Car Video Player Questions & Answers

Either the player is stuffed or the dvds are in the wrong format Try running a head cleaning disc through it there maybe dirt on the laser pickup apart from that its off to the dealer but be warned it's probably cheaper to buy a new player than get your one fixed

these guy sell concept and can get you a remote 1-888-397-1176

There is a subtitle button on the remote that you can push to remove the subtitles. EASY FIX.

I had the same problem. I had to take the cover off and mess with the tray. It was as if the tray had slipped back a bit and so it was not sensing the DVD. I pushed it forward and heard a click and it worked after that.

the disc cleaner is not exactly clean your lens! much better to open your DVD and you clean the lens with 100% cotton or cotton buds then slightly touch your cotton to lens in clockwise to remove the dirt!

sound like the wire to the parking brake may not be getting a ground.if it not get a ground it will no show a picture on the screen. it so you cant watch the dvd while driving.

Please check this https://www.google.co.ve/url?sa=t&source=web&rct=j&url=https://en.m.wikipedia.org/wiki/Tape_bias&ved=0ahUKEwjyy4nc7_vWAhVC6yYKHcwKAN0QFghdMAw&usg=AOvVaw3nn4G9wnIbrtGhPww_VaaU

75 watts on 2 channels at 4 ohms.

To the OP 'Anonymous'. There is no manual available. https://www.google.com/search?q=concept+cc-504+manual For Cricket Wireless. Here are the specs: 4 Ohm Stereo Power (RMS): 50W X 4 2 Ohm Stereo Power (RMS): 75W X 4 4 Ohm Bridged Power (RMS): 150W X 2 Signal-to-noise ratio: 100 dB Frequency Response: 5 Hz - 50 KHz Total Harmonic Distortion: 0.05% Input Sensitivity: 200mV-4V Continuously variable 0 - 18dB Bass Boost Built-in continuously variable 18dB per octave crossover, from 50Hz to 250Hz Remote bass level control "port" (remote RM-100 available separately) Platinum Connectors Length: 13" Width: 11.66" Height: 2.37"

If your amp states that it will support a range of 6 - 16 ohms, an 8 Ohm speaker will work fine on it. If the speakers you hook up to it are lower than 6 ohms, it may work until you turn it up, then it will either shut down or burn out the finals. If you hook up a speaker that has a higher than 16 ohm, it will not get very loud, and it shouldn't hurt the amp.

If there's one do 40 if two do 20s

DEFECTIVE VIDEO DRIVER CIRCUIT SEND FOR WARRANTY REPAIR IF STILL UNDER WARRANTY, IF NOT, TIME TO REPLACE, AND SELL IT ON EBAY FOR PARTS

Disconnect subs from output of amplifier and then turn on car and radio. Does amp stay on or go into protect? If it stays on then there is something wrong with the subs or how they are wired (series, parallel ) to the box and amp. If it still goes into protect then something internal with amp.

call concept at 1 888 830 1788. they are usually 29 to 39 dollars. you must specify if you have 6 or 8 pin feamle plugs.

Unfortunately, no one knows or is telling. Companies rarely state power in RMS because Peak Power is a much more impressive. 1000 watt amp, 200 watts RMS x 2 channels at 8 ohms. Look for a sticker on the unit. https://www.google.com/search?q=Xplore+Amp+5553 ..

The radio code is a security feature that's meant to deter theft, and it's unique to each vehicle. If you've lost your code, you'll need to contact a Nissan dealership or service center and provide proof of ownership. They should be able to help you retrieve the code. Please do not attempt to use codes from the internet as incorrect attempts may lock your radio.

What is your question? Thank you.

'make model (what is is)' as first 3 words in all questions. https://www.google.com/search?q=demo+mode+the+code+for+4.91 ..

This https://www.google.com/search?q=epicenter+e12-908d ..

This appears to be a South African audio device. This link might work better for you are we are in North America. https://www.google.com/search?q=jebson+stc-1052u+wiring+diagram or look for the Installation Manual. ..