Powerware PowerRite Plus UPS System - Answered Questions & Fixed issues

you can download the user manual on their website.

probably u have a board problem, and the repair can be really expensive.
good luck

the serial number can't be changed, it is burned into the circuit memory.

Most cities have local recycling centers where you can drop off paper, plastic, etc. They usually have something set up for electrical components like VCRs and batteries. The PowerRite Plus was an old Deltec model. Deltec was acquired a few times and is now belongs to Eaton. If you are looking for a new UPS, you can participate in the UPSgrade program which includes recycling your old UPS: eaton.com/upsgrade.

My guess it it is trying to get your attention for some reason. While I am not familiar with this brand, the competition brand beeps because of battery failure or impending failure.

Thanks for your interest in FixYa.com

did you fix this problem?

plz try for a compatible cord from a reputed company

if u need the ups powerboard is damaged.
the repair could be really expensive.

check the fuses inside the ups.
did the message come right after u instal de batteries or some time after?
if it came some time after the ups could have the charger damaged.
if gave the massage right after u could need to replace the fuse or u have a porwerboard problem
good luck

yes..and that happens after a period of time. When you get new ones, check the instructions on the initial charge/discharge requirements, and use those methods. tends to help with the battery life extension.

Call Eaton/Powerware and provide the serial number.

this is not from elevating transformer, fuse, batterys. the problem from charger card transitor is fail remove the transitor.

Hi, if the unit is fairly new, you may want to claim warranty check or replacement. If it has been used for some time, it may be that: 1) the battery is dying, 2) not getting enough charge or 3) too much load. For 1, battery replacement might be required. Care should be taken since this requires opening the enclosure, removing the old battery (might have acid leaks) and replacing with a new one. For 2), any competent techncian could diagnose and repair. For 3) try removing all other loads to the UPS and just run the PC with the monitor and see if the problem still exist. Hope this works for you and please let me know how things trun up. Regards.

Sounds like it is not regulating the voltage and current charging the batteries. Consult a service manual to look for a repair method.

Check the manual - https://powerquality.eaton.com/products-services/legacy/9120-info.asp?act=smtc&id=&key=&Quest_user_id=&leadg_Q_QRequired=&site=&menu=&cx=3&x=8&y=6

It either means the ground wire in extension cord is not there or is open. It could also mean that the outlet wasn't wired with a ground back to the panel.

plug it in

fixya has nothing but advice go google and type the details in the search box

can blow diodes in the alternator and ECM

You can check the battery fuse or the charging fuse. If it's more then that it's going to be a very costly fix.