Top 20
Curtis-Mathis CM32010 TV Questions & Answers
WHITE LINES ON SCREEN NO PICTURE
These lines are called vertical retrace lines. Thin white lines will be seen the entire screen, at about one inch apart or so, and will be slightly standing position. If you wish to get more details, check
this site.
Pull up older posts there. Check the site with patience, as it has over
2200 posts now. All are related to
electronic equipment repair help. Reason and repair to this fault is described in detail at one among the posts.
I am having trouble hooking
Can you provide more detail for me? I need to know if this is your main TV by the receiver, or a secondary one. What kind of cables are you using? Also what exactly is happening when you hook this up? Feel free to email me at
[email protected]Daniel Busa
DISH Network
Customer Service
I have curtis mathis model
i had the same problem but i knew the cause (dog stepped on it ) what i did after looking on-line is simply opened the case of my remote (00052d) with the batteries still in and light on the remote and halfway through "popping" the hold clips down one side, the remote light shut off and it started working properly. i think that a case support strut inside was depressing a pad and that might be your problem hope this helps
The tv screen has gone
Tv have 3 colors guns like R,G,B colors.Tv is missing one of it color gun.Have a soldering iron and a roll of solders? Take the tv aparts,resolders the video board soket pins holes that connected to the CRT-(tv tube).Resolder the Yoke wires like R,G,B connected to the main board too.Will solved this problems.
How do u hook up
U have a RCA AV component cable R,Y,W just hook that up for the out for the VCR-out put holes and the other end of the cable R,Y,W just hook it up TV-in input holes.That it,now put TV in Video 1 or 2 and play the VCR- VHS tape.Look in ur Phone book Yellow pages.Tv repair,any tv shops can do the CRT-tv analog tv repair.
I am trying to program
because this tv has no hyperband tuner (also called sometimes s-band or superband tuner 70-99).
but if you have an old vcr with a good tuner built in u can watch these channels over it (even a broken one which dont play anymore would do it still :))
regards
I have a working 1993
We would be happy to help you with getting your DISH Network remote to control your TV. located on the top of your remote until all mode button back lights come on, then release. Use the number buttons to enter the codes foryour Curtis Mathis TV; here some of the codes we currently have: 516, 670, 219, 507, 674, 680, 708, 664, and 650. Press the pound (#) button. To check that the code works try several different functions on the remote to make sure it will properly operate the TV. Keep in mind that some codes may not be compatible with your equipment. If this is the case, please try the other codes listed for that device until you find one that is compatible with your equipment.
We hope this help and thank you for being a valued DISH Network customer!
Phillip Chang
DISH Network Customer Service Representative
I have a curtis Mathis flat screan television and
Since I can't find anything about your set except the fact that it's an older set I suspect that the trouble lies in the fact that Fios won't control a set this old. I do believe this one has an analog tuner which is now obsolete.
Regards
I need a universal remote control for my tv.
You can go to many shops and they sell them, depending on the model of your TV all you have to do is type in the code in the manual which comes with the universal remote control and it will control your tv.
jonno
Not finding what you are looking for?