Top 20
Proton NT-3460 32" TV Questions & Answers
I have an 8-9 year
Hi:
when using DVi input you will still need two audio cables for the DVI output to get audio, DVI does not carry audio as with Hdmi cables if you are using a DVI to HDMI adapter then you will still have to use the DVI Audio Output jacks for audio.
My proton t.v turn off and i need to replace the
Hello
I've tried a few minutes ago to get the serial number of your TVs LOT, before I present a solution before you. I've went through all sites, that I know, where I can get the LOT serial number, but went in vein.
Replacing the LOY with an other type, and number will surely spoil your TVs most of the components.
You just do one thing. Goto an electronic spare part shop, with the LOT in your hand, and inform them about the details of your TV. They can help you. By checking its winding continuity, they can select the right one for you. Winding continuity is important and should ckec properly. You can't check the winding continuity of the EHT winding, and it is ussualy shorts, and that short causes the LOT get damaged. The base connection windings won't short at all, and you can check its by measuring its resistance with a multimeter, and choose a suitable and exact replacement.
Never put any unknown LOT. Ok.
My proton hdtv is only 3 1/2 years old and it just
This sounds like it could very well be a failed capacitor. I would take the back off the tv and inspect the capacitors on the boards and see if any are bulged or leaking. Most likely being that its a 32" you may want to consider replacing it as it would be a wiser investment over repair. If you need further assistance please let me know.
thank you,
Lee
Protron PL TV-3250 32" LCD
sounds to me a power ICB has gone bad if you can get it replaced under warranty that is your best bet. If not then you can call the manufacturer and have them fixes still at your expense. I would call them in advance and get a price for it all general estimation. Make sure its what you want to do.
hope this helps answer your problems
Nate 08:38:28cst
Where do i plug dvd vcr player into tv there r 3 sets of red yellow&white
Select an input set on the back (example "Video 2"), use the RCA cables to connect the video component player to the selected input. yellow is video signal, red & white are the audio. To view/listen, select with the remote using the button called "TV/Video" or something similar. Hit the button repeatedly until you are viewing the desired source.
Black screen with audio available
Only thing I can tell you here is contact proton. This is a hard company to get any customer service from after you buy a product . I also may suggest go back to where you bought the set, maybe they have a servicer who can get you an owners m,anual and give you the info your looking for. Good Luck
Taiwan Headquarters US Distributor
Address: PROTON USA
15364 E. Valley Blvd
City Of Industry CA 91746
U.S.A
No.77, Sec.1, San -Ming Road
Panchiao, Taipei-Hsien, Taiwan, ROC
Email:
[email protected] [email protected]
Telephone: +886-2-2962-5135 PH 626-855-2129
Fax: +886-2-2964-8664 FX 626-855-2147
Proton tv model LT32C1P1 won't come on
Fault to the main power supply regulator section. Either it will be a separate board, or the part of main board. Check and replace damaged component/s at its main power regulator [SMPS] section circuit. Contact any service technician. If you wish to get some details; check the site linked here. Surf the site with patience. Pull up older posts.
http://electronicshelponline.blogspot.com/
It will be best to replace the power supply regulator board as card basis rather than making "Surgery" to it; which usually will make loss for both money and time. Even though you can make it right, it will cost around an amount equal to the cost of a new board; including the cost of (spare parts + service charge) More to say, most of the spare parts to it will be difficult to get from open electronic spare part market. This is true to most of the flat panel TV power supply boards; irrespective of its brand and screen size.
Black rectangular box shows on screen
This is simple: set in the closed caption menu (some cable boxes also have it) called TEXT. Look in the menu and turn it off first in the set and also in the box used if used for signal.Odd feature and never really took off--designed so some channels like PBS etc could broadcast text.
Not finding what you are looking for?