20 Most Recent Canon IR1018J Black and White Copier - Page 2 Questions & Answers

Hello,
You can reset it in service mode...

Procedure:

Press the Additional functions
key, 2key, 8key, Additional functions
key sequentially.


Choose:
#CLEAR > PWD and press OK

Turn the printer off and back on.

If this doesn't do the trick under clear choose ALL and ok. After clear all you will loose all data inside!


Hope that helps!

This sounds like a faulty fuser assy. Basically the machine is warming up but nevers gets to temperature. The lamp has probably blown and for some reason it is not giving any error.

I would put a new fuser in and all should be well.

something is wrong with the fixing.it might be teflon /element or the pressure springs

you have to download system software in copier, it can be done by Canon engineer.

Fixing film rotation error

Try this...
Press and hold #'s 1 and 9 and turn the machine On. If the same message on LCD, call service center.

They will upgrade the firmware of the main controller of the machine using Service Support Tool which is available only in Canon.

Hi,
you need to call service because your system is collapsed. Its fixed over service support tool and new firmware.

Pull paper tray out and set aside,
in the back there is white lever above the spring
push lever in ,a black actuator should drop down
if it does not it may be broken or stuck.
The tray select button on the control panel should allow you to use the side tray.

You have to download the ir1018 Service Manual. from a download center.

There is a charge but it's not much though. Service manuals for Canon machines are never free - sorry. Good Luck.