Chamberlain Clicker Universal Remote Control KLIK1U - Answered Questions & Fixed issues

as it requires extra power to lift the door, it may be overloading on the current setting.check the wires and connections for the full up micro switch as it may be playing up as the door comes up.

Has it always been that way, or just recently. Most garage doors will open for about 100 or 200 feet away. If it just started, you can replace the remote battery. Hope this helps.

You might have to reprogram the remote to sync up with the opener. The instructions will be in the owners manual. Some have a button on the rear or side of the motor unit you push while pressing the remote. The sequence is critical to the unit learning the remote code.

Here is the video that will show you how to do it! https://www.youtube.com/watch?v=MxxgSTOePY8&feature=youtu.be

You should not have to reset the code. Simply remove the old battery and insert the new one, being careful to observe the polarity when you replace the new battery, and you should be good to go. The batteries can be obtained at most Wal-Marts, Radio Shacks and even through eBay if you know the correct number. Thay are lithium and will last a few years under normal use.

Is the garage remote infra red or radio? Does the universal remote support both modes of operation? If it's infra red then simply follow the programming instructions for the universal as normal. If RF then you may need another type of universal remote control that supports RF modes

Erase all remotes (usually similar procedure to programming, but hold the button longer) from the door you don't want (it's on the opener/receiver, not the clicker) then program only the one you want.

you can find them almost everywhere

the front bottom slides down, from just under the buttons

Are you holding the program button until the light comes on?

Change the code. Some one near has clicker with same code.

See the article here: See the article here on http://www.ehow.com/how_6544683_program-...

Actually, this remote can be used with Genie Garages. See the article here on eHow - I used this to program a KLIK1U to work with my Genie Promax 2 garage. Hope that helps!

You're going to have to clear the memory on the openers. This is usually done by holding the learn button for about 15 seconds or until the led turns off. I'm not sure exactly what opener you have, so this may not be the case, if not, let me know exactly which opener you're programming your remote to.

Hi, not sure what instructions you have, but the ones you can download are very clear here is a link Chamberlain Clicker Universal Remote Control KLIK1U

You can use a universal garage remote control kit, you get a new receiver and remote and it is possible to add a wireless keypad. Universal Garage Remote Control

Here are the instructions http://teknuw.com/wordpress/wp-content/uploads/2011/01/KLIK1U.pdf

Chamberlain Clicker Universal Remote Control Manual
2nd from the bottom

If one works OK, and the other has poor range, then it is either a battery problem (try swapping batteries with the good one) or it is faulty and needs to be returned to where you purchased it.

Here is a link to the instruction manual and instruction video.
Chamberlain Clicker Universal Remote Control KLIK1U