20 Most Recent Whirlpool Duet WFW9550 Washer - Page 8 Questions & Answers

when the machine is stopped can you empty the residue water that remains by the programme selector? if not check for blockage in the pump(coin), the hose internal blockage ,or at the outlet under sink. I hope this help

seems to be the bearing has gone the drum(inner metal) is rubbing on the outter which is plastic . this will eventually cause leaking

im gessing its a front load.. under the door switch there is a plastic tab that you pull about 1 cm down it aint easy to reach but its there you need to slide your hand in there and feel it

Try unplugging it for about 5 min and allow it to reset and plug it back in and try it again.

Almost certainly faulty bearings check for vertical movement in the drum if so, not good very expensive repair

You need to replace the door boot and dry out the bottom of the machine

Chek that the door lock is activated if not replace the door lock the other possibility is the anti flood device is activated so chek for a leak in the bottom of the machine

Check the filter and drain pump

It sounds as if you have a split pipe or a detached pipe from the top loading drawer or the pump is blocked and back filling to a place where it can leak out .
Check the pump is not blocked up first .
Then take the lid off without touching anything start up the machine, get a torch and look for a leak . Make sure you don't touch any wiring whilst the lid is off or you may get an electric shock.

problem is with speaker on the board ! or check the menu setting might be possible that you have switch off the alert tones

It is possible but not recommended at this could prove a costly mistake if opened by accident

The F21 error on a Whirlpool Duet washer means the unit was draining slowly. This can be caused by a blocked outlet hose (kinked hose, for example), excessive suds from using non-HE detergent or too much detergent, blockages in the drain pump filter (coin catcher), or a problem with the pump. You should be able to clear the error by pressing Pause/Cancel twice. Check your outlet hose. Then unplug the washer. Have a bucket handy to catch the water when you access the pump. Remove the toe panel from the bottom of the washer. There are three screws to remove; then you need to lift the panel slightly and pull it forward.Check the filter for foreign objects. Test the washer by selecting a cycle and running it with no clothing or detergent. If the unit still fails, then the pump, pump motor or the pressure switch is bad. However, you should also check the wiring to the unit. I hope this helps. Please add a comment with the model of your washer for specific directions and parts information. Cindy Wells

sounds like you nailed it.

sadly u may have a bad control board? its not communicating with the hardware of the appliance? not sure what else it may be?

F7 motor triac fault . best to contact your supplier, as its still under guarantee!

is this kinda pressure switch u was needing to knw?

Unfortunately, you can't just replace the bearing because the bearing is located in the rear half of the outer tub. This is an extensive project but if you still feel like tackling it, then goto YouTube.com and type in, "How to change tub bearing on a whirlpool duet load washer. You can get a visual description for a DIYer. I hope this helps you out. Good luck to you.

if it is just a knob try pulling it back out some

usually a out of balance problem check to see if washer is level and not wobbly check the front and both sides with a level