20 Most Recent Kenmore 43052 Front Load Washer - Page 8 Questions & Answers


You can try and tighten it or replace it. Could have loosen from vibration

Kenmore Washing... | Answered on Apr 09, 2019


Kenmore and whirlpool use the same type adjitater. After many years the top part of the adjitater (the spindle)
Will go bad. When it does, it will make a clicking grinding noise. Sometimes over stuffing or large comforters will cause this to happen. To find out if it’s broken do this; place your hand on top of agitator. If u can turn it easily clockwise AND Counter clockwise. You have a broken adjitater. If u can turn it one way ONLY. Then it’s a different problem. Fixing this problem is vary cheep. 5 dollars for the parts.
4 in pack. They are called Dog Adjits.
They r installed deep inside the spindle. This can be broken for years
And go unoticed because the bottom half will still work. Try the test and see
for yourself !!! Good luck.

Kenmore Washing... | Answered on Apr 06, 2019


Hi Geoff, your washer has a bad tub bearing. Depending on the age of the unit and how much you paid for it,you might want to go shopping for a new one. The bearing is pressed into the tub at the factory and is almost impossible to remove without damaging the outer tub. The outer tub can be replaced but is a time consuming job,so most companies charge a lot because you have to strip down the whole machine. Hope that helps.

Kenmore Washing... | Answered on Apr 02, 2019


Cycling occurs because a warm water wash has been selected.

The hammering is a plumbing problem - not the washing machine.

Kenmore Washing... | Answered on Apr 01, 2019


I DON'T KNOW. ENSURE SAFETY LID CLOSURE SWITCH IS WORKING. ALSO
<https://www.searspartsdirect.com/washer-repair/error-codes/kenmore-402-model-front-load-washer-error-codes.html>
<https://www.searspartsdirect.com/repair-guide/washer/how-to-replace-the-drain-pump-on-a-front-load-washer.html>

Kenmore Washing... | Answered on Apr 01, 2019


I DON'T KNOW. I RECENTLY FIXED A SIMILAR WASHER PROBLEM. THE SAFETY PLASTIC POINTER ON LID NO LONGER REACHED THE SAFETY CUT OFF SWITCH UNDER A HOLE IN THE WASHERS TOP.
I TOOK TOP OFF WASHER, TESTED SWITCH WITH METER. IT WAS OK. I RAISED THE SWITCH WITH A RIBBON OF COATED ALUMINUM METAL. WORKS LIKE NEW.

Kenmore Washing... | Answered on Mar 31, 2019


The water level sensor or selector switch may have to be replaced.

Kenmore Washing... | Answered on Mar 29, 2019

Not finding what you are looking for?
Kenmore 43052 Front Load Washer Logo

Popular Tags

36 questions posted

Ask a Question

Usually answered in minutes!

Top Kenmore Washing Machines Experts

fordexpert

Level 3 Expert

5692 Answers

Kristen Denison
Kristen Denison

Level 1 Expert

13 Answers

Jim Chinnery
Jim Chinnery

Level 1 Expert

10 Answers

Are you a Kenmore Washing Machine Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Kenmore Washing Machines

  • Kenmore Washing Machines

Most Popular Question

get loud noise during spin cycle sounds

  • Washing Machines
Loading...