20 Most Recent Kenmore 43052 Front Load Washer - Page 10 Questions & Answers

Press the Options and Select buttons at the same time and hold for 3 or 4 seconds to unlock the control panel. Best Wishes

Check your cogs. Pull the top off agitator off and look inside. Depending on model has different typed of cogs that slide and catch when working properly. The do wear out. Also known as "dog ear cogs". Very cheap parts. $2.

The leak is likely to be from the bottom hose to the circulation pump. Pull the machine out and lean it back against the wall. Have someone steady it as you look underneath,

There might be an issue with the house water supply for the washing machine that needs to be repaired or replaced or the hose could be clogged or needs to be replaced.

see if broken wire to display

The tub seal could be broken or or ripped or torn and the tub bearing and the tub seals both need to be replaced then for your washing machine and dryer machine combo.

Check out the videos for lots of ideas. https://www.google.com/search?q=Kenmore+High+efficiency+W10420384A+grinding+noise ..

Yes, but you normally have to remove the case. In the case of a stackable unit, sometimes you can get in from the back panel. https://www.google.com/search?q=kenmore+stackable+washer%2Fdryer+417.94702300+replace+water+level+sensor ..

There should be one bolt down inside the agitator that you have to get to. Or like this video it has some weird plastic device that you still have to unscrew: https://youtu.be/lRlCO_yEfsc

It happens to me every time I do that same thing. Be careful when you adjust water levels.

Probably the gearbox as it is the only part you haven't mentioned. Check to see if the belt is broken? They are not easy to work on as the case has to come off. Remove the console, undo the case screws.

repair clinic.com

Try disconnecting from the power for 10 minutes to reset it..

The machine is designed with an automatic water level sensor that even in a deep setting allows at the most 5 inches of water. The reason for this has to do with government regulations regarding energy efficiency. While you could check intake hoses, this does not change the facts. This would seem to possibly limiit the wash load. I would refer to the manual for any insight about that. My suggestion is to place the laundry evenly distributed just below the top holes of the basket.. For me to say it had 3.5 cubic feet capacity is of little value because who measures laundry by cubic feet. I hope the suggestion is of some help. https://www.hunker.com/13410750/troubleshooting-a-kenmore-700-washer https://readytodiy.com/kenmore-washer-wont-fill-keeps-filling-fills-but-not-enough-0051/

Poss. Outlet hose/trap blocked or hose kinked.

Disconnecting from the mains power for 5 minutes is normally the best reset procedure. Some have additional button press combinations. https://www.google.com/search?q=Kenmore+417.61712510 ..

Question edited for clarity. Google says this is the manual. Page 11 has the dimensions. https://c.searspartsdirect.com/pd-content/is/content/Sears/L0305262 ..

Start button could be damaged or faulty.

The F5 error code indicates that the Central Control Unit (main machine control board) detects a temperature sensor resistance that is out of the normal range. The F5 error is normally caused by a failed NTC temperature sensor.

The line fuse has blown for your washing machine and should be replaced.