Elna Heirloom Edition 6005 - Answered Questions & Fixed issues
Needle threader
www.sewingpartsonline.com has your part
# 734515009, it is kind of pricey at $12.99 but it is worth having the correct part. This company is wonderful for parts and very quick service. You will like them.
The needle thread won't connect with the bobbin thread to make a seam
it will be one of a couple of things, easiest to fix would be needle in backwards, not fully into the needle holder, or wrong gauge needle for the machine.
Or harder to fix, the timing is out. If you have hit something hard while stitching or broken a needle you could have knocked out the timing. Not so easy to fix yourself and best taken to a sewing machine mechanic if you suspect this is the problem.
What does feed dog lever do on my Elna 6005
Feed dog lever should lower the feed dogs, these are the teeth that grip and move the fabric foward and backwards as the needle goes up and down, they are under the needle plate.Only time you would lower the feed dogs is if you want to do free motion embroidery or darning perhaps.So no, don't touch for normal seam stitching. If you are sewing very heavy fabric you may want to lessen the pressure on the presser foot a little (if your machine has this adjustment it will be a knob on top of the head above the pressure foot area).You may find that your machine doesn't really like very thick fabrics. Sewing something like upholstery weight with a domestic machine is pretty ambitious; an industrial strength machine is best bet.
Spoolcase assembly
Do I understand right, you unscrewed two screws on the bobbin case holder and lifted it out? Underneath is a black plastic ring (inner guard ring) which sits inside the lower guard metal outer.
I guess you undid the bobbincase to clear under it, I have seen machines with a lump of lint under turned into felt from being left so long. While its out, clean the underside and under the inner guard ring with your little brush, chech the bobbin case holder side too, there is a little groove on the side and sometimes tiny bits of thread will be caught in it.
The trick is to turn the flywheel until the lower guard cutout open bit is facing 6 on a clock dial, ie closest to you. Now look at the inner guard ring, it has a flat edge cut off, turn it so the cut out faces about 7 on the clock and centred in the outer guard. Now you need to insert the bobbin case, it has a piece with two "beaks" on it, this is the front and these beaks need to sit between two metal parts in front of the outer ring which holds the bobbin case firmly. Put the front part in place and the whole case will fit in perfectly, just give it a little wiggle if it doesnt quite line up. Tighten the two shinny silver screws to fasten in place.
There is a little black screw too but dont touch this, its a fine tension adjustment.
Hope this assists you, if not post again andI will try to find a photo of the assembly.
Elna 5300 manual
check with sewusa.com & see if they have one on their websiteif they don't email them & ask them if they know where you canget one
Not finding what you are looking for?