20 Most Recent Euro-Pro Fast and Easy 420 Mechanical Sewing Machine - Page 7 Questions & Answers

Am unable to locate a picture of your machine, but the attached link is threading instructions for a 416. Perhaps it is close enough to your machine model to be beneficial: Euro Pro 416 Sewing Machine Threading Diagram Oh yes, one more HINT: ALWAYS RAISE the presser foot when threading the top thread!Otherwise, search for:Make Model threadingand see if anything comes up that is helpful.Or try this manual:https://www.manualslib.com/manual/918249/Euro-Pro-415qv.html?page=16#manualRemember that sewing machines basically operate the same. Even though the design has changed over the years, the threading process and sequence remains the same.

Search for: Make Model manual

Search for: sewing machine timing Lots of web sites and videos available.

Do you mean kind of like the one linked to here? If so, these are pretty common with consumer electronics (DVD players, amplifiers/receivers, etc.) so you might even have one laying around. If not, they are not difficult to find at electronics supply stores. 12 18GA Polarized C8 style Power Cord By Distributed By MCM 23 196 MCM...

Have you checked underneath the reed dogs for jammed thread and lit build up?

try this link... Six Common Sewing Machine Problems Solved ..or this link... http://www.sewusa.com/Sewing_Machine_Repair/Sewing%20Machine%20Troubleshooting.htm or this... Helpful Hints to solve machine problems

See if you can remove the bobbin from the machine. Most likely the bobbin and upper threads are entangled and have trapped the needle. You can remove the presser foot and loosen the needle from the needle bar (as though you are going to remove it). Then if you get a small pair of scissors in there and start nipping thread pieces and removing them with tweezers, you may be able to loosen it up. ...

Could be a computer board has failed.

Search for: Make Model manual

Cap??? What specifically is a "cap" on a sewing machine.

Be very careful. Stitching without the knife could damage the loopers (if the fabric laps over into the looper path). Most upper knives can be disengaged by pushing in and rotating upwards at the same time. ...

The instructions are in the manual: Euro Pro 9120 Instruction Manual Table Of Contents ...

Try installing a brand new needle. Bent/damaged needles will sometimes not pick up the bobbin thread. Make sure the machine is threaded correctly. Check the bobbin--ie, it is turning the correct direction in the bobbin case and is threaded properly through the bobbin tension. You might also try pulling the bobbin thread up to the top before beginning to stitch. How and Why to Bring up the Bobbin Thread ...

Here's a manual: Euro Pro 420 Instruction Manual Troubleshooting is on page 62. P.S.--it is usually a good idea to always raise the presser foot when threading the upper thread. That helps seat the thread in the tension disk. Also, change the needle often (ie, every time a new project is begun or whenever it is damaged/bent/dull. ...