20 Most Recent Euro-Pro 9105 Computerized Sewing Machine - Page 2 Questions & Answers

I had the same problem ! I had to take it to be repaired, they had to take it apart & grease the whole thing, I hadn't used the machine in a couple of years & the original "grease" became too hard for the foot to come down.

Good morningI will give you the same advice as I gave here a minute ago.Go to the yellow pages or on line and find an authorized dealer for your machine in your area. Take contact and ask for the correct bulbs be sent to you.enjoy your coffeekolbrun

Manufacturer's site: http://www.sharkclean.com/manual/9105_REV_0902.pdf

check with these sites

sewingpartsonline.com

whitesewingcenter.com

sewingpartsdirect.com

sewingsupplieswarehouse.com

sewforless.com

sewvacdoctor.com

check with these two websites

sewingpartsonline.com

sewvacdoctor.com

As far as the power cord, you can ask for it as "figure of eight power cord". At the other end it will have a plug suitable for your local electricity. Here is a link for buinig this cable on line.
As far as the user manual, follow this link, and at the new window click at "click here to start download from Mediafire..." like the screen bellow:

Save the manual at any place at your computer because it's not easy to locate it at the net.

In case of a problem or clarification or further details needed, don't hesitate to post me a reply before rejecting my answer.
If you are satisfied, accept my solution.

Thanks and regards
Stelios
direct FixYa link: http://www.fixya.com/users/technical114

Sears PartsDirect has manufacturer-approved replacement parts and accessories for Euro-Pro sewing machines.

For retiming instructions email [email protected]

Check to make sure the needle is up all the way into the clamp. If the bobbin case now has sharp edges from the impact. polish away the sharpness with an emery board or simular. Once a needle is hit it canot be used again so always use a fresh needle.

check with sewingmachineparts.net

try sewingpartsonline.com

You can find it here:
http://ifixmachines.com/index.php?page=shop.product_details&product_id=3365&option=com_virtuemart&Itemid=54

sewingpartsonline.com

try this
make sure there is a 3-5 inch tail on bobbin thread
make sure there is a 3-5 inch tail on top thread, then hold the top thread tail with your fingers (away from the needle) & with your other hand turn the hand wheel manually on the right side of the sewing machine,, slowly letting down the needle down into the bobbin area & see if the bobbin thread will pick up this way