20 Most Recent Euro-Pro 534DX Mechanical Sewing Machine - Page 5 Questions & Answers

https://www.manualslib.com/manual/451800/Euro-Pro-9105.html https://www.manualslib.com/manual/451800/Euro-Pro-9105.html

Search for: Make Model manual ,..

Search for: Make Model manual

Tel.: 1 (800) 798-7398 www.euro-pro.com

Search for: Make Model manual Euro pro ep550 manual Google Search

-Not exact look but you find at Lowes or Home Depot. Good luck Mai

.. https://www.sewingpartsonline.com/euro-pro-sewing-machine-parts.aspx http://sewingparts.co.uk/machines/clip-on2/euro-pro-9125.html ...

Following the maintenance instructions in the manual. Oiling incorrectly could damage the machine.

The only factory standard settings that you need to worry about is the top tension and the bobbin tension. The standard factory top tension is the midway point between high & low numbers. That is the ideal tension setting for most fabrics, thread, and needles. However, that is also adjusted based on what you are sewing. Bobbin tension you should leave as is unless there are issues that the top tension will not resolve. The other settings you mention are all adjustable based on what you want to do with your machine, ie straight vs zig-zag stitch, etc.--no standard factory setting.

Try manualsonline.com.

Try tightening the little screw that holds the shank on the machine.

Search for: Make Model manual

When buying such power adapters, you typically need to watch for:

1. DC voltage - in this case 19V. This needs to be the same.
2. DC amp rating - since your adapter is rated at 6.32A, you need a replacement that is rated at a minimum of 6.32A, but there's no harm in going higher. Your device will only draw what it needs.
3. DC plug polarity. Most are center positive, as is yours.
4. DC plug size. This is defined by inner and outer diameter. In your case, it's 5.5mmx2.5mm
5. Input voltage. You haven't mentioned your region, but it's a good idea to get international power adapters that accept 100-240V.

You've stated that you prefer to use the existing power cord, but this is an unnecessary constraint - it's better to use the power cord that comes with the replacement adapter

Search for: Make Model replacement parts

rethread the needle as the thread has no tension

Check your needle position and your threading of your machine sometimes these work read your manual get a magnifying glass a part may need replaced.

Please check whether it is the bobbin thread or the top thread that is messing up. If it's under the fabric, it is 99% the top thread and is called bird nesting or thread nesting. Remove the top thread from the machine. ALWAYS RAISE the presser foot and rethread from the beginning. Verify the thread path is correct. Also check that the bobbin is loaded and turning the correct direction in the bobbin case. Now, retest the machine. You may need to tweak the tension to get it where it looks best. ...

Am unable to locate a picture of your machine, but the attached link is threading instructions for a 416. Perhaps it is close enough to your machine model to be beneficial: Euro Pro 416 Sewing Machine Threading Diagram Oh yes, one more HINT: ALWAYS RAISE the presser foot when threading the top thread!Otherwise, search for:Make Model threadingand see if anything comes up that is helpful.Or try this manual:https://www.manualslib.com/manual/918249/Euro-Pro-415qv.html?page=16#manualRemember that sewing machines basically operate the same. Even though the design has changed over the years, the threading process and sequence remains the same.