20 Most Recent
Husqvarna Viking 1 - Page 8 Questions & Answers
Embroidery unit device disconnected
Sounds like cable has become disconnected inside machine or emb unit. Have it checked by authorized Viking Dealer. Check website http://www.husqvarnaviking.com/us for nearest Viking dealer.
Oiling
Suggest checking the user manual. Manuals can be viewed, downloaded, or printed at
http://www.manuals.husqvarnaviking.com
Use sewing machine oil which is a clear oil. Or you can use Tri-Flow Lubricant which is available at most bicycle repair shops.
Thread viking 3310 bobbin
Check the user manual. You can view, download, or print the manual from the viking website -
http://www.manuals.husqvarnaviking.com
Stich size is stuck on baste
Sounds like the feed dog stepper motor has gone bad. It will need to be replaced by an experienced service technician. Suggest you use an authorized Husqvarna Viking dealer for repair. You can find your nearest dealer from their website and use Locate a Dealer -
http://www.husqvarnaviking.com/us
Feed dogs not pushing fabric through
Remove the needle plate and make sure there is no lint obstructing the feed dogs. If they are clear, it is usually the feed dog step motor gone bad. You should have your machine serviced by an authorized Husqvarna Viking dealer. You can find your nearest dealer at the Husqvarna Viking website -
http://www.husqvarnaviking.com/us
When I use the buttonhole
Hi,
According to your problem change the settings of your machine. Reset can make your machine working.
Bobbin filled -won't shut off
The bobbin sits on a bobbin holder for winding. To initiate winding, the winder leaver should be pushed toward the bobbin on the holder.
If the bobbin is over-winding, the winder leaver needs to be rotated so that the section pointing towards the bobbin is closer. This can be done by gently rotating the winding leaver by hand, remember gently. It will not need much rotation, so do not overturn ... most of all be gentle. If it does not budge, the screw in the middle of the winder lever may be loosened and the winder leaver rotated. Make sure to tighten the screw when finished.
This should get the bobbin comfortably full. If the bobbin still continues to over-wind then the sensor underneath may need attention by you local technician. Do not attempt to open your Viking 1 as it may cause extensive damage and.will also null all warranties
Let me know how you go. Cheers.
Have a new computer with windows 7. my old
You will have to maintain an XP computer or buy new software there is no fix for your problem.It's the electronic age the old software was written for the XP operating system.When MS changed the operating system Husqvarna Viking had to design new software it's that simple.Don't blame the manufacturer Microsoft made the changes that created the problem.
www.sewvac.com
HOW TO THREAD A VIKING SEWING MACHINE MODEL# 300GH hUSQVARNA
All Vikings are pretty much the same Start at back of machine go threw tiny hook / Then go down the track / catch on the hook then down into the other hook just before needle thread needle . Make sure nobody has messed with your tension that its set at the little red mark . also make sure your bobbin slides easily but not to loosely off bobbin that you have thread it into place.
Not finding what you are looking for?