20 Most Recent
Janome Memory Craft 10000 - Page 4 Questions & Answers
Janome 10000 reliable after repair
I would think that cost would be part of your decision. A new mother board could be expensive. But your Janome MC10000 was a very expensive machine to begin with. I would ask the ladies on the forum at Janome for their opinions.
Bobbin jumping
Check your bobbin for burrs, if you find any gently sand with fine grit sand paper.
New screw for hoop
Any Janome dDealer will be able to order for you, just specify which hoop and machine....or take it to the shop to show them is best
My bobbin thread is showing threw the top when i
Sue, try this checklist- are you using 60W or #60 bobbin thread? Is your needle fresh (sharp)? Are you using a good stabilizer that's appropriate for your fabric? Is your fabric tight (not too tight) in your hoop? If all the answers are yes, your tension on your machine may be off or you may have bobbin issues. Also, if your machine uses a round shank needle, check to make sure it's in the right position. Maybe this will help
Not finding what you are looking for?