Janome Memory Craft 9000 Computerized Sewing Machine - Page 3 - Answered Questions & Fixed issues
How do I clear the memory?
What size lettering are you using? You can try smaller lettering or a larger hoop.
also try going to edit then clear.
I have loops on the bottom of my work , top thread not tightening .How do I tighten it .
If this is happening during embroidery, please make sure the presser foot is in the down position. With the embroidery foot on, it's sometimes hard to tell.
The check spring in your upper tension may be bad. You won't be able to fix it yourself. Take it in to your local repair shop.
The last option is to remove the needle plate and bobbin case. Turn the screw on the front 1/4 turn to the left, no more. If this doesn't help, leave it alone and take it in to the shop.
My janome memory 9000 squeaks when embroidering
If it squeaks when you are embroidering and not when you are sewing, it's the belts on the embroidery unit. From use, they can become glazed, slick and then they squeak.
If it squeaks when you are doing either, it's more than likely an internal lubrication of the machine that needs to be done by a trained technician.
Cheers,
Kelly
Embroidery Services
San Diego, CA
Servicing and cleaning my sewing machine
Hello Hazel
The Memory Craft 9000 is a computerized sewing machine. In removing the casing precautions must be taken to prevent damage to the electronic boards which are costly to replace. As a result it is recommended by the manufacturer (Janome) that this work be performed only by qualified technicians with the required equipment to prevent any damage.
What is the reason for requiring the casing to be removed?
Why is bobbin thread showing through on pattern
you need to loosen the top tension. if you notice the tension is too loose on top and bottom at the same time then go ahead and tighten the bobbin tension a small amount. then you can adjust the tension of the top. if the top thread tension is too tight the thread from the bobbin will penetrate through. the opposite is true. if the top is too loose then too much of the top thread will penetrate the fabric underneath. remember to get the tensions between the top tension and bobbin tension equal so the knot will end in the middle of the fabric.
Problem with knee lift
are you sure it is in all the way and it is far enough away from your table so it is not catching on anything ?hope this helps
10/17/2014 12:43:03 PM •
Janome Memory...
•
Answered
on Oct 17, 2014
•
117 views
Not finding what you are looking for?