20 Most Recent Konica Minolta Di1610 Copier - Page 2 Questions & Answers

open then close the front door -> the display show " CHANGE DRUM ? YES/NO " -> press yes on the board

Try set manual,by pass tray.

please described

Transfer .Belt and fuser need to be replaced, just like the image unit Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/normanj_7893313f0751935f

Power OFF/ON while holding the Panel Reset and No button, then access the tech mode and change the ADJUST in the TC type to 0 for USA.

If there is paper trapped physically then it must be removed mechanically by removing the roller assembly and resetting. You need to check forr pieces of paper that have jammed or is obstructing the sensor as it displays the error.Now if there is no paper locked within it can be failure of the optocoupler sensors that is causing the error. There are placed at the take up paper in-detect section and can be confirmed using a test for continuous voltage feed from the sensor.

i dont understand your languages

developer gain problem .if ur a rep then u can adjust the gain in the service mode.it is tricky but possible .otherwise u have to install new developer and initialize it.this will solve ur problem