20 Most Recent GE Profile Performance WPSF4170WAA - Page 6 Questions & Answers

The water valve went out. It’s Stuck open.

google it .

sounds like a bad door switch u7 can test it with a multimeter to show resistance

order new one

Total nightmare this HF stuff. New GE GUD24 stackable and clothes come out dirtier than they go in. (Lint) And this sensor is so off, I singe queen set of sheets (Top, bottom, 2 pillow cases) even on 'Power Wash' with 'Deep Rinse,' - check near the end of the wash cycle the sheets are not completely wet! I was able to adjust the pressure sensor on my old unit but cant' find it on this one. Barely ranks to be called a colts washer.

check belt if ok check under agitator for bad cogs

try you tube for a video we do not have them here

Take the lid off and see if the weights, springs and shock absorbers are all fixed securely and working.

perhaps the brain has failed . only a good repair shop can test .

Could be a defective cycle timer

either the control board or the pump is bad

Set the load to large, set the water temp as hot as it allows, pour in two cups of bleach and run it with no clothes.

remove fabric option then long extension and screw at bottom could be reverse threads

possible springs holding tub loose or off or tub spinning off balance bad bearings or loose

Not a lot of places it seems. Looks like you may have to measure it and ask one of the parts suppliers to look in other makes https://www.google.com/search?safe=off&rlz=1C1QJDB_enCA643CA644&sxsrf=ALeKk00NOki3UBFcUEuZbXbfgr7kLQwq9g:1610763693757&q=ge+insta+blender+replacement+gasket ..

possible bad belt if ok bad motor or check under agitator for bad cogs to tub

There could be a defective cycle timer or a defect in some controlled assembly.

Go to applianceparts.com for parts and assistance in repair.

either belt slipping or bad cogs to tub

remove fabric softner top then remove screw at bottom and wiggle agitator off