Sanyo DP42848 LCD TV - Answered Questions & Fixed issues
Picture has blackish coverings that move across the screen ... those areas can not be seen well. Comes & goes. We turn it off for a bit & then it works fine but comes back.
Sounds like The main power supply regulator section circuit fault. Either it will be a separate board, or the part of main board. Check and replace damaged component/s at its main power regulator [SMPS] section circuit. Contact any service technician. If you wish to get some details; check the site linked here. Pull up older posts.
http://electronicshelponline.blogspot.com/
It will be best to replace the power supply regulator board as card basis rather than making "Surgery" to it; which usually will make loss for both money and time. Even though you can make it right, it will cost around an amount equal to the cost of a new board; including the cost of (spare parts + service charge) More to say, most of the spare parts to it will be difficult to get from open electronic spare part market. This is true to most of the flat panel TV power supply boards; irrespective of its brand and screen size.
Search the site by type in the "brand name" to your device; in the "Search box at the top right of the display window of the Homepage" to get gathered related posts.
Black spots on screen and scrambled picture
Well this cloud be due to 2 reasons
- It could be that you are have low reception from your DTH operator or cable operator
- There could be fault in our TV
You better get it checked by a professional or contact Sanyo
NOTE: the first one applies only if all the TV's in your home are acting the same way
How do I get streaks off the screen?
I use a brand new microfiber cloth. Mist the cloth with a spray bottle a few times with clean water. And brush the screen lightly with only the microfiber by folding the cloth into a square. If the stain is persistent try a LCD screen cleaning product
Dnttv cuts on and off
Are you sure of the part number? I do not see a 1aa4d10n202oa among the parts for the Sanyo DP42848. I did find the 1aa4b10n2020a (key control) from several sites but there is a 3 digit prefix on the part number at Shop Jimmy . com among others. (Not all sites have this in stock.)
I hope this helps.
Cindy Wells
No picture Sanyo dp42848
Back-light problem. Check and replace damaged component/s at its
back-light inverter board, or replace this board as card basis. If you wish to get some details; check the site linked here. Surf the site with patience. Pull up older posts.
It will be best to replace the inverter board as card basis.
http://electronicshelponline.blogspot.com/
SANYO DP 42848 NTSC to PAL
The TV you specified here can only be used with NTSC system transmission or video data. If you wish to see PAL system signals by this tV, you've to buy PAL to NTSC converter, and should connect it according to connection diagram given along with the converter.
Inverter board
It all depends on the person doing the job they can make there own prices. cost of the board + time + storage until part come+ time it takes to put the part in and test tv. some will put in the part you got if it is the right one but most will not. some place's get the parts cheap and you pay the full cost of what it would be. hope this help. look for a repair place only they are usually the best place to start as they only do repairs and not sales.
Not finding what you are looking for?