20 Most Recent Electrolux EIFLW55HIW Front Load Washer with IQ-Touch Controls - Page 2 Questions & Answers

www.electrolux.co.nz/Support/Manuals/

Good Afternoon Friend, I understand that you are trying to remove the dispenser cover for your Electrolux washer, model# EIFLS60JIW. The cover is locked in 3 areas of the dispenser, where the cover meets the dispenser. The right side, the middle, and the left side. All you will need to do is pull up on the cover and it should come apart from the dispenser. I ask that you please follow up with a comment on the post, at your convenience, to advise if further troubleshooting is needed or if your washer status has changed successfully. Hope this is helpful. -Best Regards- WP

Not a solution, but I wonder if it thinks you've either selected no spin or it thinks the machine isn't drained and so won't spin or it thinks the load is unbalanced. You seem to have done everything logical so far. Also look at all all connectors Logic seems to dictate that if the motor/motor drive functionality and other diagnostics don't show any problems (although I must admit if it were possible I'd like to try another motor control board just to convince me it wasn't implicated) then it must be a logic/ sensor problem and maybe diagnostic mode doesn't check all sensors in the same way as would happen in normal use? Sorry I can't be of more help. (The motor brushes are probably ok but I'd check them anyway while you are in there) Do let us know if you find anything.

check you have your washing machine level even slightly tilt in front

If you pull the lower front of the drum gasket away from the drum you will see some drain holes. This a common area for a stray sock to get wedged.

Good Morning Michael, I understand that your washer door will not lock and it is inoperable. Let's try resetting the unit by either unplugging it or flipping the household circuit breaker off. Wait approximately 2 minutes and turn on the washer. Select a normal cycle and verify if the washer will start. If the appliance will not operate then it possibly have a faulty door lock assembly or a communication problem with the control board. I would suggest contacting an experienced service technician to determine the precise cause.

Go to link below.. remember Google is (a) god..(send) http://www.electrolux.co.nz/node38.aspx?productId=31106

Hello wsmith454 - From what you are describing, more than likely the bottom drawer possibly has a faulty latch. If I was in your position, I would personally suggest contacting a professional to accurately assist with the repair or installation of the part.

Suggestion: There could be a plastic lever which is used to take the drawer out to clean, inbuilt in drawer. Take the drawer out to re-fit.