Top 20
Patton PUH680-U Utility Heater Questions & Answers
Heat 1 & 2
Typically 'Heat 1' means first stage heat and 'Heat 2' means second stage heat. Essentially a Lo and Hi setting. Just like a hair dryer.
Starts then shuts off
My Mighty Heater 1500 will run for 15sec then shuts off then repeats it over an over
I received the Patton Electric Heater model number
I saw your post and I encourage you to report your problem to The U.S. Consumer Product Safety Commission. I called them to report the problem. The number to the company (Patton) is 763 444 8567. The number to The U.S. Consumer Product Safety Commission is 1-800-638-2772. The U.S. Consumer Product Safety Commission will take your report and if you know others that have this product and they have experienced the same thing encourage them to call and report it. The heater I had melted unto a ultility extention cord and was smoldering. It could have cause serious injury or damages to me and my family.
If this product could have injured you as well. The are a public hazard and need to be recalled.
I have a Patton Heater ( Brand New ) that was
Try spraying a LITTLE WD-40 on the fan bearings, with the heater unplugged, of course. You may have to remove the case to get access. Before you spray, try to spin the fan with your finger. Spray then try again with the finger. I think this will do it. If you don't have WD-40 ... try sewing machine or other light house hold oil.
Thanks for visiting today.
I was told this heater
Yours may or may not have not have been involved in the recall. The link below has all the info on the voluntary recall.
http://www.cpsc.gov/cpscpub/prerel/prhtml84/84025.html
If the link doesn't work, copy and paste it into your web browser.
I heard on a local
http://www.kztv10.com/news/wal-mart-heater-recall/
This link should help.
CAN THIS HEATER CAUSE AFIRE AND IS THIS HEATER ON
I do not know if this heater is on any product recall but we have used patton heaters for years and pretty much have had good luck with them. However there is a fire hazard present if you set or store combustibles to close to the front.Tip over switches don't always work and I would never recommend using a heater of this type in a unsupervised area.I hope this is of some help to you. Thank you and happy holidays.
Shuts off after 15 mins
its hitting the high limit temperature switch...
is the heater clean inside? clean any dirt or dust off the fan blades and vent grills.
Is the fan turning and running at proper speed?
I have 2 of these
If it was banged in any way some thing got stuck to it need to inspecked it
Puh662 light comes on fan
You will need a continuity checker-- Do you have this tool?
Check for continuity, from one side of the plug, all the way in thru the switch, the thermostat, the limit device, and thru the elements, and back to the other side of the plug..
Somewhere you have an open circuit.
Track it down--
Let me know what you find, and let me know if I can help you get to the next step?
Mack B
Heater shows it has power
I go thru several of these a year, the fan motors for the most part go out on them or the safety for overheating. I find that at $19.00 it is easier to replace than repair. If you add up parts costs freight to get them to you and your time you go well over the cost of repair. If you wish to dabble there are two switches in mine, one is a tip switch usually on the bottom and a heat sensor to protect against over heating this will usually be at the top looks like a button with two wires one in one out. Both can be jumped out to see if they are bad can run this way as well but not recommended unless it is in close proximity to you, never let it run unattended.By the way this is not a fix but an easy way to trouble shoot only.
Not finding what you are looking for?