20 Most Recent Kenwood KM400 / KM410 Chef Classic Stand Mixer - Page 3 Questions & Answers

can you tell me where the gearbox is situated please?

hi,
this will help you out

http://www.rigpix.com/kenwood/r1000_service.pdf

thank you,
vijay (vote for me)

Yes,
DISCONNECT POWER
if you remove the top cover, you will find an overload group with a green and a red button on top, next to the contactor . One is test, the other is reset. On the side of the overload are two thumb wheels, one is auto/ manual, set this to auto, the other is -15%,0, +15%. If you are running very heavy batches and you want to push your motor harder, move it to +15, but it's not recommended. If it was set to manual, when it trips and cools down, it will not reset untill you press the reset button, in auto, once cool you an restart the mixer.

It is possible that the drive belt has broken. It is located under the housing on top of the mixer but you need to remove 2 screws under the housing then remove the 3 retaining screws on the drive mechanism. The top of the housing will then lift off and reveal the drive belt. Caution this is not a DIY job for non mechanically minded persons and as always make sure the equipment is disconnected from the power supply. If in doubt seek qualified assistance.

Hello.

the difference between A701A and A901 is :

high speed outlet
slow speed outlet

planetary hub is similar . A701A, A901 and KM series

A701 Different planetary hub and fit different tools.

is not same A720 and A920 A7 = A701/A
A9 = A901 and KM

In our web site Kenwood Chef Restore in Downloads section.
you can download the compatibility of the models A700, A701 , A900 and KM series .

Regards

if you have max speed you have to replace the .1uf capacitor the 2 spring loaded screws serve far fine adjustment

Please, sometimes we can supply some spares parts

please let me know if you still need some parts.

Regards

Kenwood Chef Restore

I have an A901. The label on the machine says that it is 1/3 Hp (one third horse power).

you can call your local hobart branch for the part number,but you use lithium grease in the unit.in order to change the grease the transmission needs to be opened and so does the planetary. i service these mixers alot i work for hobart.if you need any more help/questions let me know.