Top 20 Lanier 1205 Copier - Page 5 Questions & Answers

Dirty thermistor in the fusing unit.

It is in the Ricoh maintenance kit.

What kind? most one screw in front cover pull handle tward you remove finisher

IH inverter current error at power on. Either the fuser is damaged or the invertor coil is defective. You really should have a Ricoh tech look at that one. It is not an easy fix for the layman.

Check IP address sub net, ect?

User tools system settings- interface settings-(or the tab next to it) auto specify sender to on, you also have to add an administrator e-mail address for the administrator

Under user tools, system settings make all prints, copies to come out in internal tray, the front and rear covers have to come off to remove screw 1 each side the SC code is shift tray motor error

Fuser error code Push clear modes 1 0 7 then hold stop for 5 seconds

THIS IS FUSER UNIT

Did you try postscript driver from the Lanier website?

This is just a shot in the dark, but if there is no "reset" button, you might try unplugging it for a couple of minutes and it should reset itself. Just a guess. If you have an owners manual, I would check there to find how to solve this problem, but this may indicate the print heads are damaged in that area. You might enter the "menu" if there is one, and run any maintenance tools available to see if that corrects the problem. If you don't have an owner's manual, you might be able to find one at the printer manufacturer's website in the support section. This would give you a better idea if the problem was a do-it-yourself fix or whether you will need technical help.

Please more detailes refer to problem.

run the CLEAN mode.orRemove the toner cartidge and clean the rollers.This happens when you use cheap paper. The dust gets on the roller drum and grays or streeks the copies

The boys at the office figured out how to get out and empty... Thanks for all your input... I had sent it on to them.

Clean the **** glass. It is a long skinny glass to the left of the big rectangular glass under the feeder. Clean it and your problem should go away.

Precisionroller.com/

You can set your print job to print with no color. When you go to print, there should be an options / settings tab. click that and set it to print black and white.

its a moisture issue in the paper. try nice new dry paper and i bet it works fine

Try cleaning the polygon motor found in the laser unit, maybe you need the service manual. The motor must not rotate for lack of cleanliness. Good luck ...

Eenter in the service mode press yellow key - 107 - red key(stop) keep press for 5 seconds,enter in the SP mode open the front door,turn OFF the main switch,wait 15 seconds close the front door,turn ON the power switch.