20 Most Recent
Element Electronics FLX2211B 22 in. LCD TV - Page 9 Questions & Answers
Element tv no picture just sound already replaced inverter board. What else could be wrong
Check voltage supplied to the back-light inverter board; from the main power regulator board. If there is no voltage; check for the reason. If there is voltage; and still the back-light does not turn on; two possibilities are there.
1. Damaged back-light lamp/s.
2. Start up voltage to back light inverter board does not comes from the main board. If this is the case, main board is faulty. Contact any service technician; if so.
If you wish to get some details; check the site linked here. Pull up older posts. Surf the site with patience.
http://electronicshelponline.blogspot.com/
Faults & possible causes to LCD screen are given with illustrations. You can get an idea about the fault to an extent.
1/17/2015 9:09:22 AM •
Element...
•
Answered
on Jan 17, 2015
What part needs to replaced on Element TV?
I have three of these TVs in the shop. They are less than a year old. The signal board is good, the T-con board is good, and the power supply is good. The panel (once called picture tube) is bad. Much too costly for repair. Thanks for asking me.
1/9/2015 5:31:35 AM •
Element...
•
Answered
on Jan 09, 2015
How to chage height on screen
To adjust the height of the screen, you have to enter its service mode option. If you wish to get some details; check the site linked here.
Pull up older posts. Surf the site with patience.
http://electronicshelponline.blogspot.com/
Service mode entry, adjust and exit procedure to many popular brand TVs are given. Never forget to exit the service mode, after all adjustments have been done.
NB: Please read and understand well, the instructions to enter the service mode, before you begin. Be very careful.
Note how to "EXIT" the service mode; after entering and adjusting data. This is very important.
12/15/2014 6:16:08 PM •
Element...
•
Answered
on Dec 15, 2014
Not finding what you are looking for?