20 Most Recent Sharp 32SC260 32 inch TV - Page 6 Questions & Answers

Please checked LVDS cable is fix properly or not. Remove cleaned and refix.

Most likely it indicates that there is an error. When the light is blinking all of the time. You will need to troubleshoot to narrow down the problem and find the solutions. Problems can occur and happen and show up from hardware issues or the firmware that is installed on the TV.

Replace your motherboard

Your TV might of had died on you guys and it could also be a power supply problem with the TV too.

Good make and a good set. It is well worth taking it in for repair and getting a quote. I wouldn't try repairing it yourself https://www.fixya.com/support/r29790007-repairing_own_television ..

This sounds like a power board issue, if you unhook all boards and power the power supply up does your standby voltage seem steady?

Sounds like you got a bad replacement power board, hopefully it didn't come from ebay as that isn't the best place to buy TV parts

You've lost video, I'd start by replacing the tcon board

Hi Bruce, don't replace boards without knowing what board is bad, power the set up and test the various power board output rails after it's shut down, if all look ok most likely it's your main that's bad if one or more aren't correct according to the legion on the board it's the power supply.

Pull the wall plug out of the socket and it will go off.

It has Auto Tracking. Possibly control head is dirty.

Read the manual? Google make model manual Go to settings - Wifi and enter SSID and Password. That's it. Go to the Smart Hub and choose your Apps. A wireless keyboard makes things easier.

Question edited to put things in the right order for search. Try Remove and Replace.com. There is a similar set service manual at ManualLib.com. https://www.google.com/search?q=sharp+lc-58q733ou+service+manual ..

the TV's screen is blue is due to and also caused by the source or the input device that has not been set up in the correct mode. Check to make sure that the video source to your TV cable and satellite box and streaming device or antenna is on and your cables are connected in properly.

The 2 slow one long blink code for Sharp/Element TV's is backlight inverter over current/voltage shut down and not a board issue. Replace the backlights and the set should work like new

I can't give you the screw size. They are metric screws. The part number is CX-BZA329WJ01, https://encompass.com/model/SHALC32D47UA . There are other sources for the part. I hope this helps. Cindy Wells

Hi Andy, try a replacement main board, that should correct the issue

Question edited for clarity. Yes, change all the boards. It is best to buy 2 or 3 of each. :>D This is what you will find https://www.fixya.com/support/r29790007-repairing_own_television ..

Calibration settings https://www.google.com/search?q=sharp+aquos+tv+calibration+settings ..

Chances are your backlights have failed Don, very common issue on this and many other model LED TV's