20 Most Recent
Whirlpool Inglis IP8200 Dryer - Page 9 Questions & Answers
Whirlpool duet gas dryer is not working. The
check the door switch,if this switch is bad dryer wont work,this is a spdt type switch as it runs the drum light when doors open and lets machine start and operate with door closed
Whirlpool Duet dryer error code
E1=Thermistor open
post your email and i will send you the steps to fix and check it too much to type here
10/25/2021 7:47:57 PM •
Dryers
•
Answered
on Oct 25, 2021
What is f04 Whirlpool 6th sense?
F04 indicates a fault in the heating circuit.
It can be a main board, wiring, thermostat or heater fault.
You would need to check the heater and thermostats with a multimeter to ensure they are not open circuit.
.
However, the first thing to try is a reset of the control board.
.
Turn the dial to off.
Turn the dial clockwise to the 6 o'clock position.
Press the start button 3 times
Turn the dial 1 position clockwise.
Press the start button 3 times.
.
This should erase the code.
Try the machine again.
If the code comes back, you need to check out the heating circuit.
If you change or repair any part, reset the board, then try again.
I have a whirlpool dryer LER5636EQ3 that will shut off after 3-5 mins.
I'm wondering if the motor may have a problem & getting too hot it most likely has a breaker built into the motor that shuts it off if it gets too hot . If that's the case it should reset after a while when it cools . You might try running it then when it stops let it sit for a while & see if it will start again . If it starts let it run when it stops again feel the motor & see if it is real hot . Just something you could check . Hope this helps
Not finding what you are looking for?