20 Most Recent Amana NED7200TW Electric Dryer - Page 3 Questions & Answers

it is part of the board the only way to get the light is to find an appliance bone yard and try to find one

this means there is a problem with heat circuit

It means there is a leak. You should turn off the gas flow to the drier immediately until it is fixed!

The E5 error code is only referenced by a technician. More than likely it refers to a circuit board problem. Only solution is to have it replaced by a technician.

Yes stackingkit 5303937141 to stack them

Check your power source, then the cord to make sure it is connected to the dryer properly, and not shorted.

check you drum belt. if belt is broken nothing will come on.

Hi Marissa, Have you run the diagnostic program to find the fault? Your problem could be the high limit thermostat, thermal fuse or the heater. Take the panel off at the back and locate the tech sheet. On the tech sheet you will find the instructions for running the diagnostic program. Run the diagnostic program and this will tell you where the problem is and the corrective actions needed. It is a bit involved to get at the thermistor, but easy to replace. see http://www.youtube.com/watch?v=mCmGRijX_14, as this leads you through the process very well.

You must remove the top and then the console and then you can remove the screws holding the front on.