Pride Mobility Products Jazzy 1103 Ultra Electric Wheelchair with Powered Seat Lift by Pride Mobili - Answered Questions & Fixed issues

1-800-800-8586

Since you have replaced the batteries and the charger there is most likely a problem with the wiring.

Walter on the Jazzy try pressing the on/off button twice to unlock Hope this helps You can go to pridemobility.com to download a users manual Hope this helps you

The serial number is on the tag with a lot of numbers. Those are the serial numbers. the model is Jazzy 1103 Ultra. Hope this helps

Many power wheelchair controllers are able to be programmed for speed, acceleration etc. There is normally a separate programmer that you need to plug ino the the power wheelchair. Your supplier should have one of these.

If you do not know your local supplier, have a look on the manufacturers website. If it is pride mobility, then try www.pridemobility.com.

Contact your retailer and explain this to them. They are in the best position to help you with this matter.

Look in your owners manual for the flash code anwser. Make sure when you hit the power button you only touch it for 1 sec not more. If you press the power button for more the 2-3 seconds you place the power chair in LOCK OUT mode. lights will flash and not power. also check your free wheel levers. one on each moter. Mike

try replacing the battery fuse

the motor will automatically brake the scooter to stopped and keep it locked there until it is running again or put manually in neutral.

Usually when things electrical get wet they fail.

Try this site: https://shoprider.com/resources/user-manuals

From a pure physics standpoint... The energy to climb a hill... be it from the steep side or the gentle sloping side is the same... It is just easier on your heart and joints to take the gentle slope... (assuming you have the time). ERGO: If treating the scooter like a QUEEN is your goal... DEFINITELY GO SLOW. Tat way you will have no idea if it has any weak spots when you need it to go fast (and you will). I'm old... I don't have TIME to waste! Carnac the Magnificent

Maybe too late for this advice but it is important to take a detailed photograph of the wireing before unplugging anything.

Hi not much info is there a red LED & green LED on charger...or is there a red LED & orange led on ?? Bit more info would help cheers

Hi check the main circuit breaker c photo push the white button in to c if it has tripped open cheers

Yes a technician with a programmer can set the control very slow so it is limited on how fast it can go. Otherwise the joystick is meant to be adjustable, so setting it to one speed only not possible. I’m happy to assist further over the phone at https://www.6ya.com/expert/bill_bcbb89783b08c489

hi Linda, can you please tell me what model pride this is ? Regards Rob

Candy Apple paint is extremely hard to patch repair. It has a base coat of silver or gold and then multi coats of the candy apple over the top. You can get a paint that is meant to be a touch up for candy apple but you never end up with the same shade of color. Most of the time it will come out dark blood red anywhere that it over laps the old paint. I would contact Pride as they may use a paint that does not require a base coat.

Check you're freewheel lever if its in freewheel u have to take the key out engage lever & put key back in. Also if u have left the key on for more than twenty minutes the circuit will shut down only the light will work. take key out for 5 minutes then put it back it should work unless it's another problem good luck

Bearing probably.