Top 20
Kohler K-15160-7 Coralais single-control pullout spray kitchen sink faucet Questions & Answers
The line connecting to the sprayer hose was bent
Kathryn, the kink could restrict flow of water because there is so much less room. To remove the kink you could try pressing the two sides of the kink BUT that is risky. Have a replacement ready in case you damage it further. DO ALL THIS WITH WATER SHUT OFF. If you manage to straighten the kink even a bit more, water will flow better.GL
I have a Kohler faucet (K-15160). All of a sudden
Ours was purchased in 2002, I called Kohler 800 456 4537, followed the prompts and pressed 2 for technical help, still followed them for kitchen products and stuck with it until I reached a rep. I explained, the problem, they mentioned a O ring and lubrication was needed, I added that the mechanical bind I was feeling couldn't just be from a fouled O ring, they then added all of the valve internals to be sure.
should be here in 2 to 5 days all free of charge. Though it may have been better to replace the entire unit, they mentioned they would if this didn't take care of the problem. It was a pleasure to work with them.
Water volume slowed down
Sounds like you may possibly have some sediments in the screen on the spray head. When you pull the head out you can disconnect it from the flex supply line and see if the water pressure is okay with out the head connected. This will either confirm it is in the spray head or valve body.
I have poor water pressure from the faucet, hot
could be a number of things.
most mixer taps have flexible braided inlet hose's make shure there not kinked.
also there may be built pressure reducing valves,usually removerable,a plumbers job really.
is there servive valves on hot and cold if so make shure there fully on.good luck ,any qs ask
The pullout spout leaks
pull out the spray part and tighten the nut around the hose or take it loose and replace the washer
Not finding what you are looking for?