20 Most Recent Kohler KOHGP51487 Authorized Original Replacement Part Tank Gasket For All - Page 8 Questions & Answers

use the adjustment clip and pull off...reinstall by leaving a few links on chain for slack...try a few times to see if ok...good luck..

I had that happen due to water level on being high enough in tank. I increased my tank water and problem stopped for me. I also adjusted the flapper chain that also helped. I also replaced the flapper and it was also worn out.

this could be problem...you could strip out screw if you try to hard...try pushing in hard as you turn...you could spray with jb blaster lube spray and let sit for 30 minutes or so and retry...keep this up until it loosens...

you should have installed some type of control limiter...did it not come with one...look at instructions and you should see that part...check this and see...

sounds like the temp limiter is either missing or not engaged properly...you have to remove handle and check if plumber install this or not...good luck

pull heads and make sure no trash in system....

Just from what you described it sounds like it works if you bypass the float? Then you have a bad float, or it is stuck.

Air Switch Repair It sounds like you have a bad air switch located in your motor. The air switch is what the air hose connects to on the back of the motor or on the box on top of the motor. The other end of the air hose is connected to the air button on the lip of the tub. This is a latching air switch and when you push the air button it latches to send power to the motor. When the air button is pushed again it opens the latch in the air switch and stops power going to the motor shutting it off. US Parts Center Bath Spa Replacement Parts Hot Tub Bath Parts Accessories US Parts...

Yes. Fluid master brand makes a great replacement unit that is reasonably priced. It is available at the big box hardware stores.

Bathtubs have no filters. The only fitting that people assume is the filter is called the suction Cover however there is no filter media in any bathtub. US Parts Center

That will happen with any and all iron sinks. When the temperature from ice cools the sink & the air in the house is hot then condensation will form quicker. To stop this I would suggest you melt the ice by spraying sink tap water on ice.

Your dispenser nut is either not tightened down underneath or your plastic base/o-ring needs to be replaced. Turn off water at value. Using sink nut removal & installation tool that is available at any Lowe's or Home Depot. Remove it and look at what is wrong. Conntact Kohler for free parts to repair it. Reinstall dispenser .

It is possible that the vent pipe behind the toilet is clogged (or was not installed properly). Some bathrooms are set up with one shared vent pipe, and a clog in one of the lines leading to it can cause similar problems. The vent pipe in each bathroom does 2 things: 1: it lets the sewer gas go past the bathroom and up out the roof so you don't get sewer gas in the house. 2: It breaks the siphon as water goes from fixtures down to the big sewer pipes in the house. If it isn't working for a sink, it's not much of a problem because air gets mixed in with the water as it does down the sink, and this breaks the siphon. But in a toilet, it jsut keeps pulling water down the pipe until the water level in the toilet gets low enough to let air into the pipe, breaking the siphon. It's not an easy problem to fix and often involves removing walls to get at pipes. A plumber can bring a snake tool and try clearing the pipes from below or from the roof, and might even be able to bring a steerable snake that lets him control how it goes through the pipe.

You will need to shut-off the water valves underneath the sink and remove the faucet handle(s). Once you do this, you will see the rubber "seats" which need to be replaced. Just pop them out and replace them with new seats and replace the handle(s). Turn on the valves underneath the sink and your faucet should be all set!