20 Most Recent Price Pfister RT6-E0XC/HHL-ELBC/0X6-040 Catalina Deck Mount Whirlpool Fauce - Page 2 Questions & Answers

Yes, the aerator (where the water comes out) can be unscrewed and removed from the faucet. I remove these and clean them out on a regular basis. If the aerator won't unscrew by hand, place a washcloth over the aerator (to prevent scratching) and carefully turn it with a pair of pliers. (Screw direction to loosen: Looking down on faucet, with pliers to the right-hand side, pull them toward you.) Make sure the rubber washer is properly placed in the top of the aerator after you have cleaned it out and you go to screw it back on. You normally don't need pliers to put it back on, as these are meant to be screwed on hand-tight. There might be several little parts inside the aerator to take apart and clean out, so be very careful to put these parts back together the same way they came apart. I find a toothpick is often useful to clean these out, as well as a cup of water to rinse them in.

It may just be a screw loose or you may need to check the washer and o-ring inside. Dont take anything apart if your not comfortable in doing that. Get someone who does.

You can buy the 900-259 part on the links below.

http://www.efaucets.com/detail.asp?product_id=900-259&KID=343471468788241705&gclid=CPW24ves5KkCFQ9VgwoddlJn8A

http://www.lockeplumbing.com/detail.asp?c=Faucet%20Parts%20P%20through%20R&s=Price%20Pfister&s2=&sku=PRI-900-259-260&r1=WHE-USS25C&r2=GRU-595916&r3=FEI-NL9-LED

If you are in Los Angeles and not to far from Orange where I am, You will want to go to biard and crockett plumbing. They will have it in stock. They are 10 mins from disneyland. Here is there web site and address below.

http://www.bcpsi.com/

replace the diverter valve washer and seat

HELLO- This type of valve has a two piece catridge,you will have to adjust it till it reaches the hot water inlet. A little tricky but you can do it, be sure to shut water off to shower!!!!! Good luck.

1. Remove Handle Assembly (9A)
2. Unscrew Retainer Sleeve (9B)
3. Remove Flange (9C)
4. Remove Stem and Bonnet Assembly (9D)
5. Pull out Balancing Cartridge (9E)

I hope that answers your question.

Next time you go to the hardware store bring a pad of paper and a pen.

Maybe he is not the sharpest tool in the shed, you need to call a plumber!!!!!!

If this is what your unit looks like and you want the handle to be in this position when closed then you need to loosen the handle (small set screw on the handle) and repossession it where you want it be in the closed position and snog the set screw down.

See instructions here
http://pricepfisterparts.faucetdirect.com/mediabase/specifications/8P8-PD_INSTALLSHEET.pdf

there is a bockage in the cartridge. flush it.

I would say it is a washer on the stem, here is a website that will assist you:

http://www.pricepfisterparts.net/