20 Most Recent DigiWeigh 100 X 0.01 Gram Digital Jewelry Pocket Scale - Page 2 Questions & Answers

Try recalibrating it by turning it on while holding the "tare" or "mode" button. It should show a raw data from the sensor then. Press the tare button again and it should calibrate the empty weight. Then it will show a specific weight you should put on, usually 100g. It should automatically finish calibration now. Hope this helps. The words before calibration on my scale was OUt2

Easier to use pennies. 9 copper pennies from the 1960s or 1970s weight 1 oz.

Check to see if you need new batteries, or just remove batteries and reinstall to reset device. If you need further help, reach me via phone at https://www.6ya.com/expert/frankie_091f536560a54e12

Try this - While it is off, press and hold both the mode and the tare* keys at the same time and press the On/Off key - Release the keys and observe the display - cycle through a series of numbers. Press the mode key once and observe the display "CAL 0" "100.00" then similar numbers as before. This step calibrates Check here - http://wiki.answers.com/Q/How_do_you_calibrate_digi_weigh_scale_DW-100AX_or_fix_errors_such_as_F--H_or_ERR?#slide=1