20 Most Recent
John Deere 420,1020,2010,2020,2510,2520 Tractor Float - Page 8 Questions & Answers
Diesel engine wont start
With it being a diesel it could be any number of things, first step would be to get the codes pulled from the pcm.
Shuts down
sounds like your safty switch is bad our you have one unpluged some where under neath
Hood won't open and release dosen't work
try putting preasure down on the hood before you use the release lever
that can help, also if it is out in the cold it is possible water got in there if thats the case it won't open unless it get above freezing to thaw out
The 2520 has a loss of power in high gear under a load
that should have the yanmar in her, could be a few things, first off i check or change fuel filter, could also be a clogged injecter or a injector not working, but fuel problem is my first guess is filter is old and block, also a good time to drain and remove any water as well
Case 1494 steering doesn't work, hydraulic
Hi Jas,
It is likely that you have a stuck or defective relief or bypass valve in the steering box. If all other hydraulics are working normally then the issue is in the steering box. Some units have a small screen filter on the high side line but usually that presents as jerky steering rather than complete failure. I do not recommend attempting repairs unless you have a pressure gauge to set the relief pressure after removal. You may find a used box on EBay, otherwise, find a local hydraulics shop to have it repaired.
Kevin
Occasionaly the engine shuts off and won't start on JD gx345.
If the fuel pump is working correctly then the problem is between the tank and the pump. run a fuel line from the pump to a gas can. If the pump is working it will siphon the fuel into your filter. If the pump is fine then there is blockage, broken fuel line (sucking air), or something blocking the pick up inside the tank.
Park Brake circuit light on 310sj backhoe error light
Check the wire that installs into the sending unit from the origin (source). It could be pulled loose. If ok, there is a button type switch that disengages after the brake is released, this button switch could be faulty or otherwise dysfunctional.
Not finding what you are looking for?