20 Most Recent Pentair IntelliFlo VS-3050 & VS+SVRS Variable Speed Pump - - Page 2 Questions & Answers

The Intelliflo SVRS will do this everytime. The SVRS part of the model indicates that it has a Safety Vacuum Release System integrated into the pump. This means that whenever the pump senses a change in the vacuum pressure (when you connect your barracuda this happens) the SVRS kicks in and shuts the pump down.
If you want to avoid this, you either need to disable the SVRS in the intelliflo menu, Or simply push the "quick clean" button and it will run constantly with no SVRS for 1 hour.
Below is the link for the manual on this pump, this will tell you how to disable the SVRS function if the 1 hour quick clean is not sufficient time to clean your pool



http://www.pentairpool.com/pdfs/IntelliProVS+SVRSOM.pdf

Depending what type of pump you have you can use your finger with the system off and see if you can loosen the clog, if not then you have to take the motor off of the pump to access the impeller, if that is the case you may want to call a professional.

What is your Salt Level? Efficiency level is right at 3500 ppm

Ouch...!!! contact Pentair customer service

yes the display is LCD these tend to turn all black or all silver when it gets cold , what ive done to mine is install a small foam cooler from grocery store that i cut bottom out of over the panel in cool weather Only! and use the heat generated from a simple drop light plugged in to outlet by pump with a 100 watt incandesent bulb in it , that makes the display work ok for an extended season

Extensive information available is available from Pentair. Owners manual http://www.pentairpool.com/pdfs/IntelliFlo4x160and4x100OM.pdf Quick start guide http://www.pentairpool.com/pdfs/intelliflovsQSG.pdf

go to utube see the video on your pump programming sounds like you have the run time on 1200 rpm

yes turn off it sounds like moisture in pump motor

check the back of the pump motor wires are probably wet

go to utube they have videos how to program you need to set clock and set a run time

check incomming voltage and switch

its on the pump body and motor

go to utube they have videos on programming you need to set time and a run time

go to utube they have videos on programming